@@ -1214,11 +1214,11 @@ static void mvpp2_port_disable(struct mvpp2_port *port)
/* Disable & reset should be done separately */
val &= ~MVPP22_XLG_CTRL0_MAC_RESET_DIS;
writel(val, port->base + MVPP22_XLG_CTRL0_REG);
- } else {
- val = readl(port->base + MVPP2_GMAC_CTRL_0_REG);
- val &= ~(MVPP2_GMAC_PORT_EN_MASK);
- writel(val, port->base + MVPP2_GMAC_CTRL_0_REG);
}
+
+ val = readl(port->base + MVPP2_GMAC_CTRL_0_REG);
+ val &= ~(MVPP2_GMAC_PORT_EN_MASK);
+ writel(val, port->base + MVPP2_GMAC_CTRL_0_REG);
}
/* Set IEEE 802.3x Flow Control Xon Packet Transmission Mode */
This patch modifies the port_disable() helper to always disable both the GMAC and the XLG MAC when called. At boot time we do not know of a port was enabled in the firmware/bootloader, and if so what mode was used (hence which of the two MACs was used). This also help in implementing a logic where all blocks are disabled when not used, and only enabled regarding the current mode used on a given port. Signed-off-by: Antoine Tenart <antoine.tenart@bootlin.com> --- drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-)