diff mbox series

[net-next] net: 3c509: mark expected switch fall-throughs

Message ID 20190123072955.GA10978@embeddedor
State Accepted
Delegated to: David Miller
Headers show
Series [net-next] net: 3c509: mark expected switch fall-throughs | expand

Commit Message

Gustavo A. R. Silva Jan. 23, 2019, 7:29 a.m. UTC
In preparation to enabling -Wimplicit-fallthrough, mark switch cases
where we are expecting to fall through.

This patch fixes the following warnings:

drivers/net/ethernet/3com/3c509.c:1265:8: warning: this statement may fall through [-Wimplicit-fallthrough=]
drivers/net/ethernet/3com/3c509.c:1271:8: warning: this statement may fall through [-Wimplicit-fallthrough=]

Warning level 3 was used: -Wimplicit-fallthrough=3

This patch is part of the ongoing efforts to enabling
-Wimplicit-fallthrough.

Signed-off-by: Gustavo A. R. Silva <gustavo@embeddedor.com>
---
 drivers/net/ethernet/3com/3c509.c | 2 ++
 1 file changed, 2 insertions(+)

Comments

David Miller Jan. 23, 2019, 5:07 p.m. UTC | #1
From: "Gustavo A. R. Silva" <gustavo@embeddedor.com>
Date: Wed, 23 Jan 2019 01:29:55 -0600

> In preparation to enabling -Wimplicit-fallthrough, mark switch cases
> where we are expecting to fall through.
> 
> This patch fixes the following warnings:
> 
> drivers/net/ethernet/3com/3c509.c:1265:8: warning: this statement may fall through [-Wimplicit-fallthrough=]
> drivers/net/ethernet/3com/3c509.c:1271:8: warning: this statement may fall through [-Wimplicit-fallthrough=]
> 
> Warning level 3 was used: -Wimplicit-fallthrough=3
> 
> This patch is part of the ongoing efforts to enabling
> -Wimplicit-fallthrough.
> 
> Signed-off-by: Gustavo A. R. Silva <gustavo@embeddedor.com>

Applied.
diff mbox series

Patch

diff --git a/drivers/net/ethernet/3com/3c509.c b/drivers/net/ethernet/3com/3c509.c
index b223769d6a5e..3da97996bdf3 100644
--- a/drivers/net/ethernet/3com/3c509.c
+++ b/drivers/net/ethernet/3com/3c509.c
@@ -1266,12 +1266,14 @@  el3_up(struct net_device *dev)
 					pr_cont("Forcing 3c5x9b full-duplex mode");
 					break;
 				}
+				/* fall through */
 			case 8:
 				/* set full-duplex mode based on eeprom config setting */
 				if ((sw_info & 0x000f) && (sw_info & 0x8000)) {
 					pr_cont("Setting 3c5x9b full-duplex mode (from EEPROM configuration bit)");
 					break;
 				}
+				/* fall through */
 			default:
 				/* xcvr=(0 || 4) OR user has an old 3c5x9 non "B" model */
 				pr_cont("Setting 3c5x9/3c5x9B half-duplex mode");