@@ -377,6 +377,20 @@ int genphy_c45_read_abilities(struct phy_device *phydev)
__set_bit(ETHTOOL_LINK_MODE_10baseT_Half_BIT,
supported);
}
+
+ if (val & MDIO_PMA_EXTABLE_NBT) {
+ val = phy_read_mmd(phydev, MDIO_MMD_PMAPMD,
+ MDIO_PMA_NG_EXTABLE);
+ if (val < 0)
+ return val;
+
+ if (val & MDIO_PMA_NG_EXTABLE_2_5GBT)
+ __set_bit(ETHTOOL_LINK_MODE_2500baseT_Full_BIT,
+ supported);
+ if (val & MDIO_PMA_NG_EXTABLE_5GBT)
+ __set_bit(ETHTOOL_LINK_MODE_5000baseT_Full_BIT,
+ supported);
+ }
}
linkmode_copy(phydev->supported, supported);
@@ -45,6 +45,7 @@
#define MDIO_AN_ADVERTISE 16 /* AN advertising (base page) */
#define MDIO_AN_LPA 19 /* AN LP abilities (base page) */
#define MDIO_PCS_EEE_ABLE 20 /* EEE Capability register */
+#define MDIO_PMA_NG_EXTABLE 21 /* 2.5G/5G PMA/PMD extended ability */
#define MDIO_PCS_EEE_WK_ERR 22 /* EEE wake error counter */
#define MDIO_PHYXS_LNSTAT 24 /* PHY XGXS lane state */
#define MDIO_AN_EEE_ADV 60 /* EEE advertisement */
@@ -201,6 +202,7 @@
#define MDIO_PMA_EXTABLE_1000BKX 0x0040 /* 1000BASE-KX ability */
#define MDIO_PMA_EXTABLE_100BTX 0x0080 /* 100BASE-TX ability */
#define MDIO_PMA_EXTABLE_10BT 0x0100 /* 10BASE-T ability */
+#define MDIO_PMA_EXTABLE_NBT 0x4000 /* 2.5/5GBASE-T ability */
/* PHY XGXS lane state register. */
#define MDIO_PHYXS_LNSTAT_SYNC0 0x0001
@@ -272,6 +274,10 @@
#define MDIO_EEE_10GKX4 0x0020 /* 10G KX4 EEE cap */
#define MDIO_EEE_10GKR 0x0040 /* 10G KR EEE cap */
+/* 2.5G/5G Extended abilities register. */
+#define MDIO_PMA_NG_EXTABLE_2_5GBT 0x0001 /* 2.5GBASET ability */
+#define MDIO_PMA_NG_EXTABLE_5GBT 0x0002 /* 5GBASET ability */
+
/* LASI RX_ALARM control/status registers. */
#define MDIO_PMA_LASI_RX_PHYXSLFLT 0x0001 /* PHY XS RX local fault */
#define MDIO_PMA_LASI_RX_PCSLFLT 0x0008 /* PCS RX local fault */
Register 1.21 "2.5G/5G PMA Extended abilities" contains the information indicating whether or not 2.5GBASET and 5GBASET are supported by a PHY, as per the 802.3bz specification. If the bit 14 is set in the 1.11 "PMA Extended abilities" register, the modes specified in the above-mentionned 1.21 register should be taken into account. This commit adds that logic into the genphy_c45_read_abilities function. Signed-off-by: Maxime Chevallier <maxime.chevallier@bootlin.com> --- drivers/net/phy/phy-c45.c | 14 ++++++++++++++ include/uapi/linux/mdio.h | 6 ++++++ 2 files changed, 20 insertions(+)