@@ -1522,10 +1522,10 @@ static void qeth_l3_rebuild_skb(struct qeth_card *card, struct sk_buff *skb,
if (hdr->hdr.l3.ext_flags & QETH_HDR_EXT_SRC_MAC_ADDR)
card->dev->header_ops->create(skb, card->dev, prot,
tg_addr, &hdr->hdr.l3.next_hop.rx.src_mac,
- card->dev->addr_len);
+ skb->len);
else
card->dev->header_ops->create(skb, card->dev, prot,
- tg_addr, "FAKELL", card->dev->addr_len);
+ tg_addr, "FAKELL", skb->len);
}
skb->protocol = eth_type_trans(skb, card->dev);
@@ -1584,8 +1584,7 @@ static int qeth_l3_process_inbound_buffer(struct qeth_card *card,
skb->dev = card->dev;
len = skb->len;
card->dev->header_ops->create(skb, card->dev, 0,
- card->dev->dev_addr, "FAKELL",
- card->dev->addr_len);
+ card->dev->dev_addr, "FAKELL", len);
netif_receive_skb(skb);
} else {
qeth_l3_rebuild_skb(card, skb, hdr);
We need to pass the *payload* length, not the L2 address length. For qeth (using eth_header()) this is merely a cosmetic change: the parameter only matters when building headers for ETH_P_802_2 or ETH_P_802_3, whereas our fake headers are built with ETH_P_IP / ETH_P_IPV6 / 0. Signed-off-by: Julian Wiedmann <jwi@linux.vnet.ibm.com> --- drivers/s390/net/qeth_l3_main.c | 7 +++---- 1 file changed, 3 insertions(+), 4 deletions(-)