| Message ID | 1451912823-5245-15-git-send-email-peppe.cavallaro@st.com |
|---|---|
| State | Changes Requested, archived |
| Delegated to: | David Miller |
| Headers | show |
diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c index 4a75f79..76ca54c 100644 --- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c +++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c @@ -881,6 +881,11 @@ static int stmmac_init_phy(struct net_device *dev) phy_disconnect(phydev); return -ENODEV; } + + /* If attached to a switch, there is no reason to poll phy handler */ + if (!strcmp(priv->plat->phy_bus_name, "fixed")) + phydev->irq = PHY_IGNORE_INTERRUPT; + pr_debug("stmmac_init_phy: %s: attached to PHY (UID 0x%x)" " Link = %d\n", dev->name, phydev->phy_id, phydev->link);
This patch avoids to call the stmmac_adjust_link when the driver is connected to a switch by using the FIXED_PHY support. Prior this patch the phydev->irq was set as PHY_POLL so periodically the phy handler was invoked spending useless time because the link cannot actually change. Note that the stmmac_adjust_link will be called just one time and this guarantees that the ST glue logic will be setup according to the mode and speed fixed. Signed-off-by: Giuseppe Cavallaro <peppe.cavallaro@st.com> --- drivers/net/ethernet/stmicro/stmmac/stmmac_main.c | 5 +++++ 1 files changed, 5 insertions(+), 0 deletions(-)