@@ -2565,21 +2565,12 @@ static void bnx2x_set_rx_mode(struct net_device *dev);
static void bnx2x_e1h_disable(struct bnx2x *bp)
{
int port = BP_PORT(bp);
- int i;
-
- bp->rx_mode = BNX2X_RX_MODE_NONE;
- bnx2x_set_storm_rx_mode(bp);
netif_tx_disable(bp->dev);
bp->dev->trans_start = jiffies; /* prevent tx timeout */
REG_WR(bp, NIG_REG_LLH0_FUNC_EN + port*8, 0);
- bnx2x_set_eth_mac_addr_e1h(bp, 0);
-
- for (i = 0; i < MC_HASH_SIZE; i++)
- REG_WR(bp, MC_HASH_OFFSET(bp, i), 0);
-
netif_carrier_off(bp->dev);
}
@@ -2589,13 +2580,13 @@ static void bnx2x_e1h_enable(struct bnx2x *bp)
REG_WR(bp, NIG_REG_LLH0_FUNC_EN + port*8, 1);
- bnx2x_set_eth_mac_addr_e1h(bp, 1);
-
/* Tx queue should be only reenabled */
netif_tx_wake_all_queues(bp->dev);
- /* Initialize the receive filter. */
- bnx2x_set_rx_mode(bp->dev);
+ /*
+ * Should not call netif_carrier_on since it will be called if the link
+ * is up when checking for link state
+ */
}
static void bnx2x_update_min_max(struct bnx2x *bp)
@@ -10538,7 +10529,7 @@ static void bnx2x_self_test(struct net_device *dev,
/* disable input for TX port IF */
REG_WR(bp, NIG_REG_EGRESS_UMP0_IN_EN + port*4, 0);
- link_up = bp->link_vars.link_up;
+ link_up = (bnx2x_link_test(bp) == 0);
bnx2x_nic_unload(bp, UNLOAD_NORMAL);
bnx2x_nic_load(bp, LOAD_DIAG);
/* wait until link state is restored */
There is really no need to clear the MAC or the FW filtering rules - it was added for completion, but caused race conditions with load/unload. Removing this redundant code Signed-off-by: Eilon Greenstein <eilong@broadcom.com> --- drivers/net/bnx2x_main.c | 19 +++++-------------- 1 files changed, 5 insertions(+), 14 deletions(-)