@@ -2271,6 +2271,21 @@ static int sb1250_change_mtu(struct net_device *_dev, int new_mtu)
return 0;
}
+static const struct net_device_ops sbmac_netdev_ops = {
+ .ndo_open = sbmac_open,
+ .ndo_stop = sbmac_close,
+ .ndo_start_xmit = sbmac_start_tx,
+ .ndo_set_multicast_list = sbmac_set_rx_mode,
+ .ndo_tx_timeout = sbmac_tx_timeout,
+ .ndo_do_ioctl = sbmac_mii_ioctl,
+ .ndo_change_mtu = sb1250_change_mtu,
+ .ndo_validate_addr = eth_validate_addr,
+ .ndo_set_mac_address = eth_mac_addr,
+#ifdef CONFIG_NET_POLL_CONTROLLER
+ .ndo_poll_controller = sbmac_netpoll,
+#endif
+};
+
/**********************************************************************
* SBMAC_INIT(dev)
*
@@ -2327,21 +2342,11 @@ static int sbmac_init(struct platform_device *pldev, long long base)
spin_lock_init(&(sc->sbm_lock));
- dev->open = sbmac_open;
- dev->hard_start_xmit = sbmac_start_tx;
- dev->stop = sbmac_close;
- dev->set_multicast_list = sbmac_set_rx_mode;
- dev->do_ioctl = sbmac_mii_ioctl;
- dev->tx_timeout = sbmac_tx_timeout;
- dev->watchdog_timeo = TX_TIMEOUT;
+ dev->netdev_ops = &sbmac_netdev_ops;
+ dev->watchdog_timeo = TX_TIMEOUT;
netif_napi_add(dev, &sc->napi, sbmac_poll, 16);
- dev->change_mtu = sb1250_change_mtu;
-#ifdef CONFIG_NET_POLL_CONTROLLER
- dev->poll_controller = sbmac_netpoll;
-#endif
-
dev->irq = UNIT_INT(idx);
/* This is needed for PASS2 for Rx H/W checksum feature */
Signed-off-by: Alexander Beregalov <a.beregalov@gmail.com> --- drivers/net/sb1250-mac.c | 29 +++++++++++++++++------------ 1 files changed, 17 insertions(+), 12 deletions(-)