@@ -723,7 +723,6 @@ usb-phy@c5000000 {
nvidia,xcvr-setup-use-fuses;
nvidia,xcvr-lsfslew = <2>;
nvidia,xcvr-lsrslew = <2>;
- vbus-supply = <&vdd_vbus1>;
};
usb@c5008000 {
@@ -735,7 +734,7 @@ usb-phy@c5008000 {
nvidia,xcvr-setup-use-fuses;
nvidia,xcvr-lsfslew = <2>;
nvidia,xcvr-lsrslew = <2>;
- vbus-supply = <&vdd_vbus3>;
+ vbus-supply = <&vdd_5v0_sys>;
};
brcm_wifi_pwrseq: wifi-pwrseq {
@@ -995,28 +994,6 @@ vdd_pnl: regulator@3 {
vin-supply = <&vdd_5v0_sys>;
};
- vdd_vbus1: regulator@4 {
- compatible = "regulator-fixed";
- regulator-name = "vdd_usb1_vbus";
- regulator-min-microvolt = <5000000>;
- regulator-max-microvolt = <5000000>;
- regulator-always-on;
- gpio = <&gpio TEGRA_GPIO(D, 0) GPIO_ACTIVE_HIGH>;
- enable-active-high;
- vin-supply = <&vdd_5v0_sys>;
- };
-
- vdd_vbus3: regulator@5 {
- compatible = "regulator-fixed";
- regulator-name = "vdd_usb3_vbus";
- regulator-min-microvolt = <5000000>;
- regulator-max-microvolt = <5000000>;
- regulator-always-on;
- gpio = <&gpio TEGRA_GPIO(D, 3) GPIO_ACTIVE_HIGH>;
- enable-active-high;
- vin-supply = <&vdd_5v0_sys>;
- };
-
sound {
compatible = "nvidia,tegra-audio-wm8903-picasso",
"nvidia,tegra-audio-wm8903";
The configuration of USB VBUS regulators was borrowed from downstream kernel, which is incorrect because the corresponding GPIOs are connected to PROX_EN (A501 3G model) and LED_EN pins in accordance to the board schematics. USB works fine with both GPIOs being disabled, so remove the bogus USB VBUS regulators. The USB VBUS of USB3 is supplied from the fixed 5v system regulator and device-mode USB1 doesn't have VBUS switches. Signed-off-by: Dmitry Osipenko <digetx@gmail.com> --- .../boot/dts/tegra20-acer-a500-picasso.dts | 25 +------------------ 1 file changed, 1 insertion(+), 24 deletions(-)