diff mbox series

arm64: tegra: Add ID EEPROMs on Jetson AGX Xavier

Message ID 20200803154430.734683-1-thierry.reding@gmail.com
State Accepted
Headers show
Series arm64: tegra: Add ID EEPROMs on Jetson AGX Xavier | expand

Commit Message

Thierry Reding Aug. 3, 2020, 3:44 p.m. UTC 
From: Thierry Reding <treding@nvidia.com>

The P2888 processor module contains an EEPROM that provides means of
identifying the module. The P2822 carrier board contains the same EEPROM
with information identifying the carrier board. Both of them ar accessed
via the GEN_I2C1 bus.

Signed-off-by: Thierry Reding <treding@nvidia.com>
---
 arch/arm64/boot/dts/nvidia/tegra194-p2888.dtsi    | 15 +++++++++++++++
 .../arm64/boot/dts/nvidia/tegra194-p2972-0000.dts | 13 +++++++++++++
 2 files changed, 28 insertions(+)
diff mbox series

Patch

diff --git a/arch/arm64/boot/dts/nvidia/tegra194-p2888.dtsi b/arch/arm64/boot/dts/nvidia/tegra194-p2888.dtsi
index 4c005b811233..0ea0bd83cb8e 100644
--- a/arch/arm64/boot/dts/nvidia/tegra194-p2888.dtsi
+++ b/arch/arm64/boot/dts/nvidia/tegra194-p2888.dtsi
@@ -57,6 +57,21 @@  serial@3110000 {
 			status = "okay";
 		};
 
+		i2c@3160000 {
+			status = "okay";
+
+			eeprom@50 {
+				compatible = "atmel,24c02";
+				reg = <0x50>;
+
+				vcc-supply = <&vdd_1v8ls>;
+				address-width = <8>;
+				pagesize = <8>;
+				size = <256>;
+				read-only;
+			};
+		};
+
 		/* SDMMC1 (SD/MMC) */
 		mmc@3400000 {
 			cd-gpios = <&gpio TEGRA194_MAIN_GPIO(A, 0) GPIO_ACTIVE_LOW>;
diff --git a/arch/arm64/boot/dts/nvidia/tegra194-p2972-0000.dts b/arch/arm64/boot/dts/nvidia/tegra194-p2972-0000.dts
index 90b6ea5467fa..4d8a0e10250f 100644
--- a/arch/arm64/boot/dts/nvidia/tegra194-p2972-0000.dts
+++ b/arch/arm64/boot/dts/nvidia/tegra194-p2972-0000.dts
@@ -23,6 +23,19 @@  interrupt-controller@2a40000 {
 			};
 		};
 
+		i2c@3160000 {
+			eeprom@56 {
+				compatible = "atmel,24c02";
+				reg = <0x56>;
+
+				vcc-supply = <&vdd_1v8ls>;
+				address-width = <8>;
+				pagesize = <8>;
+				size = <256>;
+				read-only;
+			};
+		};
+
 		ddc: i2c@31c0000 {
 			status = "okay";
 		};