diff mbox

[v2,1/6] ARM: tegra: nyan: Use proper IRQ type definitions

Message ID 20170122154753.31942-1-contact@paulk.fr
State Accepted
Headers show

Commit Message

Paul Kocialkowski Jan. 22, 2017, 3:47 p.m. UTC 
This switches a few interrupt definitions that were using
GPIO_ACTIVE_HIGH as IRQ type, which is invalid.

This is mostly a cosmetic change, that doesn't affect any driver.

Signed-off-by: Paul Kocialkowski <contact@paulk.fr>
---
 arch/arm/boot/dts/tegra124-nyan.dtsi | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

Comments

Thierry Reding Jan. 25, 2017, 10:58 a.m. UTC | #1 
On Sun, Jan 22, 2017 at 04:47:48PM +0100, Paul Kocialkowski wrote:
> This switches a few interrupt definitions that were using
> GPIO_ACTIVE_HIGH as IRQ type, which is invalid.
> 
> This is mostly a cosmetic change, that doesn't affect any driver.
> 
> Signed-off-by: Paul Kocialkowski <contact@paulk.fr>
> ---
>  arch/arm/boot/dts/tegra124-nyan.dtsi | 4 ++--
>  1 file changed, 2 insertions(+), 2 deletions(-)

Applied, thanks.

Thierry
diff mbox

Patch

diff --git a/arch/arm/boot/dts/tegra124-nyan.dtsi b/arch/arm/boot/dts/tegra124-nyan.dtsi
index eabfa655a3cd..ef430aa30152 100644
--- a/arch/arm/boot/dts/tegra124-nyan.dtsi
+++ b/arch/arm/boot/dts/tegra124-nyan.dtsi
@@ -65,7 +65,7 @@ 
 			compatible = "maxim,max98090";
 			reg = <0x10>;
 			interrupt-parent = <&gpio>;
-			interrupts = <TEGRA_GPIO(H, 4) GPIO_ACTIVE_HIGH>;
+			interrupts = <TEGRA_GPIO(H, 4) IRQ_TYPE_EDGE_FALLING>;
 		};
 
 		temperature-sensor@4c {
@@ -331,7 +331,7 @@ 
 					reg = <0x9>;
 					interrupt-parent = <&gpio>;
 					interrupts = <TEGRA_GPIO(J, 0)
-							GPIO_ACTIVE_HIGH>;
+							IRQ_TYPE_EDGE_BOTH>;
 					ti,ac-detect-gpios = <&gpio
 							TEGRA_GPIO(J, 0)
 							GPIO_ACTIVE_HIGH>;