diff mbox series

[v2,04/40] dt-bindings: mmc: Add Tegra SDHCI sampling trimmer values

Message ID 1533924522-1037-5-git-send-email-avienamo@nvidia.com
State Superseded
Headers show
Series Tegra SDHCI add support for HS200 and UHS signaling | expand

Commit Message

Aapo Vienamo Aug. 10, 2018, 6:08 p.m. UTC 
Document the Tegra SDHCI inbound and outbound sampling trimmer values.

Signed-off-by: Aapo Vienamo <avienamo@nvidia.com>
---
 .../devicetree/bindings/mmc/nvidia,tegra20-sdhci.txt          | 11 +++++++++++
 1 file changed, 11 insertions(+)

Comments

Rob Herring Aug. 13, 2018, 7:25 p.m. UTC | #1 
On Fri, Aug 10, 2018 at 09:08:06PM +0300, Aapo Vienamo wrote:
> Document the Tegra SDHCI inbound and outbound sampling trimmer values.
> 
> Signed-off-by: Aapo Vienamo <avienamo@nvidia.com>
> ---
>  .../devicetree/bindings/mmc/nvidia,tegra20-sdhci.txt          | 11 +++++++++++
>  1 file changed, 11 insertions(+)

Reviewed-by: Rob Herring <robh@kernel.org>
diff mbox series

Patch

diff --git a/Documentation/devicetree/bindings/mmc/nvidia,tegra20-sdhci.txt b/Documentation/devicetree/bindings/mmc/nvidia,tegra20-sdhci.txt
index 9713e05..edecf97 100644
--- a/Documentation/devicetree/bindings/mmc/nvidia,tegra20-sdhci.txt
+++ b/Documentation/devicetree/bindings/mmc/nvidia,tegra20-sdhci.txt
@@ -67,6 +67,10 @@  Optional properties for Tegra210 and Tegra186:
 - nvidia,pad-autocal-pull-up-offset-hs400,
   nvidia,pad-autocal-pull-down-offset-hs400 : Specify drive strength
   calibration offsets for HS400 mode.
+- nvidia,default-tap : Specify the default inbound sampling clock
+  trimmer value for non-tunable modes.
+- nvidia,default-trim : Specify the default outbound clock trimmer
+  value.
 
   Notes on the pad calibration pull up and pulldown offset values:
     - The property values are drive codes which are programmed into the
@@ -77,6 +81,13 @@  Optional properties for Tegra210 and Tegra186:
     - The SDR104 and HS400 timing specific values are used in
       corresponding modes if specified.
 
+  Notes on tap and trim values:
+    - The values are used for compensating trace length differences
+      by adjusting the sampling point.
+    - The values are programmed to the Vendor Clock Control Register.
+      Please refer to the reference manual of the SoC for correct
+      values.
+
 Example:
 sdhci@700b0000 {
 	compatible = "nvidia,tegra210-sdhci", "nvidia,tegra124-sdhci";