@@ -254,6 +254,15 @@ config PWM_JZ4740
To compile this driver as a module, choose M here: the module
will be called pwm-jz4740.
+config PWM_KEEMBAY
+ tristate "Intel Keem Bay PWM driver"
+ depends on ARM64 || COMPILE_TEST
+ help
+ The platform driver for Intel Keem Bay PWM controller.
+
+ To compile this driver as a module, choose M here: the module
+ will be called pwm-keembay.
+
config PWM_LP3943
tristate "TI/National Semiconductor LP3943 PWM support"
depends on MFD_LP3943
@@ -22,6 +22,7 @@ obj-$(CONFIG_PWM_IMX27) += pwm-imx27.o
obj-$(CONFIG_PWM_IMX_TPM) += pwm-imx-tpm.o
obj-$(CONFIG_PWM_IQS620A) += pwm-iqs620a.o
obj-$(CONFIG_PWM_JZ4740) += pwm-jz4740.o
+obj-$(CONFIG_PWM_KEEMBAY) += pwm-keembay.o
obj-$(CONFIG_PWM_LP3943) += pwm-lp3943.o
obj-$(CONFIG_PWM_LPC18XX_SCT) += pwm-lpc18xx-sct.o
obj-$(CONFIG_PWM_LPC32XX) += pwm-lpc32xx.o
new file mode 100644
@@ -0,0 +1,232 @@
+// SPDX-License-Identifier: GPL-2.0
+/*
+ * Intel Keem Bay PWM driver
+ *
+ * Copyright (C) 2020 Intel Corporation
+ * Authors: Lai Poey Seng <poey.seng.lai@intel.com>
+ * Vineetha G. Jaya Kumaran <vineetha.g.jaya.kumaran@intel.com>
+ *
+ * Limitations:
+ * - Upon disabling a channel, the currently running
+ * period will not be completed. However, upon
+ * reconfiguration of the duty cycle/period, the
+ * currently running period will be completed first.
+ */
+
+#include <linux/bitfield.h>
+#include <linux/clk.h>
+#include <linux/io.h>
+#include <linux/mod_devicetable.h>
+#include <linux/module.h>
+#include <linux/platform_device.h>
+#include <linux/pwm.h>
+#include <linux/regmap.h>
+
+#define KMB_TOTAL_PWM_CHANNELS 6
+#define KMB_PWM_COUNT_MAX 0xffff
+#define KMB_PWM_EN_BIT BIT(31)
+
+/* Mask */
+#define KMB_PWM_HIGH_MASK GENMASK(31, 16)
+#define KMB_PWM_LOW_MASK GENMASK(15, 0)
+#define KMB_PWM_LEADIN_MASK GENMASK(30, 0)
+
+/* PWM Register offset */
+#define KMB_PWM_LEADIN_OFFSET(ch) (0x00 + 4 * (ch))
+#define KMB_PWM_HIGHLOW_OFFSET(ch) (0x20 + 4 * (ch))
+
+struct keembay_pwm {
+ struct pwm_chip chip;
+ struct device *dev;
+ struct clk *clk;
+ void __iomem *base;
+};
+
+static inline struct keembay_pwm *to_keembay_pwm_dev(struct pwm_chip *chip)
+{
+ return container_of(chip, struct keembay_pwm, chip);
+}
+
+static inline void keembay_pwm_update_bits(struct keembay_pwm *priv, u32 mask,
+ u32 val, u32 offset)
+{
+ u32 buff = readl(priv->base + offset);
+
+ buff = u32_replace_bits(buff, val, mask);
+ writel(buff, priv->base + offset);
+}
+
+static void keembay_pwm_enable(struct keembay_pwm *priv, int ch)
+{
+ keembay_pwm_update_bits(priv, KMB_PWM_EN_BIT, 1,
+ KMB_PWM_LEADIN_OFFSET(ch));
+}
+
+static void keembay_pwm_disable(struct keembay_pwm *priv, int ch)
+{
+ keembay_pwm_update_bits(priv, KMB_PWM_EN_BIT, 0,
+ KMB_PWM_LEADIN_OFFSET(ch));
+}
+
+static void keembay_pwm_get_state(struct pwm_chip *chip, struct pwm_device *pwm,
+ struct pwm_state *state)
+{
+ struct keembay_pwm *priv = to_keembay_pwm_dev(chip);
+ unsigned long long pwm_h_count, pwm_l_count;
+ unsigned long clk_rate;
+ u32 buff;
+
+ clk_rate = clk_get_rate(priv->clk);
+
+ /* Read channel enabled status */
+ buff = readl(priv->base + KMB_PWM_LEADIN_OFFSET(pwm->hwpwm));
+ if (buff & KMB_PWM_EN_BIT)
+ state->enabled = true;
+ else
+ state->enabled = false;
+
+ /* Read period and duty cycle */
+ buff = readl(priv->base + KMB_PWM_HIGHLOW_OFFSET(pwm->hwpwm));
+ pwm_l_count = FIELD_GET(KMB_PWM_LOW_MASK, buff) * NSEC_PER_SEC;
+ pwm_h_count = FIELD_GET(KMB_PWM_HIGH_MASK, buff) * NSEC_PER_SEC;
+ state->duty_cycle = DIV_ROUND_UP_ULL(pwm_h_count, clk_rate);
+ state->period = DIV_ROUND_UP_ULL(pwm_h_count + pwm_l_count, clk_rate);
+}
+
+static int keembay_pwm_apply(struct pwm_chip *chip, struct pwm_device *pwm,
+ const struct pwm_state *state)
+{
+ struct keembay_pwm *priv = to_keembay_pwm_dev(chip);
+ struct pwm_state current_state;
+ u16 pwm_h_count, pwm_l_count;
+ unsigned long long div;
+ unsigned long clk_rate;
+ u32 pwm_count = 0;
+
+ if (state->polarity != PWM_POLARITY_NORMAL)
+ return -ENOSYS;
+
+ keembay_pwm_update_bits(priv, KMB_PWM_LEADIN_MASK, 0,
+ KMB_PWM_LEADIN_OFFSET(pwm->hwpwm));
+
+ keembay_pwm_get_state(chip, pwm, ¤t_state);
+
+ if (!state->enabled) {
+ if (current_state.enabled)
+ keembay_pwm_disable(priv, pwm->hwpwm);
+ return 0;
+ }
+
+ /*
+ * The upper 16 bits of the KMB_PWM_HIGHLOW_OFFSET register contain
+ * the high time of the waveform, while the last 16 bits contain
+ * the low time of the waveform, in terms of clock cycles.
+ *
+ * high time = clock rate * duty cycle
+ * low time = clock rate * (period - duty cycle)
+ *
+ * e.g. For period 50us, duty cycle 30us, and clock rate 500MHz:
+ * high time = 500MHz * 30us = 0x3A98
+ * low time = 500MHz * 20us = 0x2710
+ * Value written to KMB_PWM_HIGHLOW_OFFSET = 0x3A982710
+ */
+
+ clk_rate = clk_get_rate(priv->clk);
+
+ /* Configure waveform high time */
+ div = clk_rate * state->duty_cycle;
+ div = DIV_ROUND_CLOSEST_ULL(div, NSEC_PER_SEC);
+ if (div > KMB_PWM_COUNT_MAX)
+ return -ERANGE;
+
+ pwm_h_count = div;
+
+ /* Configure waveform low time */
+ div = clk_rate * (state->period - state->duty_cycle);
+ div = DIV_ROUND_CLOSEST_ULL(div, NSEC_PER_SEC);
+ if (div > KMB_PWM_COUNT_MAX)
+ return -ERANGE;
+
+ pwm_l_count = div;
+
+ pwm_count = FIELD_PREP(KMB_PWM_HIGH_MASK, pwm_h_count) |
+ FIELD_PREP(KMB_PWM_LOW_MASK, pwm_l_count);
+
+ writel(pwm_count, priv->base + KMB_PWM_HIGHLOW_OFFSET(pwm->hwpwm));
+
+ if (state->enabled && !current_state.enabled)
+ keembay_pwm_enable(priv, pwm->hwpwm);
+
+ return 0;
+}
+
+static const struct pwm_ops keembay_pwm_ops = {
+ .owner = THIS_MODULE,
+ .apply = keembay_pwm_apply,
+ .get_state = keembay_pwm_get_state,
+};
+
+static int keembay_pwm_probe(struct platform_device *pdev)
+{
+ struct device *dev = &pdev->dev;
+ struct keembay_pwm *priv;
+ int ret;
+
+ priv = devm_kzalloc(dev, sizeof(*priv), GFP_KERNEL);
+ if (!priv)
+ return -ENOMEM;
+
+ priv->clk = devm_clk_get(&pdev->dev, NULL);
+ if (IS_ERR(priv->clk))
+ return dev_err_probe(dev, PTR_ERR(priv->clk), "Failed to get clock\n");
+
+ ret = clk_prepare_enable(priv->clk);
+ if (ret)
+ return ret;
+
+ priv->base = devm_platform_ioremap_resource(pdev, 0);
+ if (IS_ERR(priv->base))
+ return PTR_ERR(priv->base);
+
+ priv->chip.base = -1;
+ priv->chip.dev = dev;
+ priv->chip.ops = &keembay_pwm_ops;
+ priv->chip.npwm = KMB_TOTAL_PWM_CHANNELS;
+
+ ret = pwmchip_add(&priv->chip);
+ if (ret) {
+ dev_err(dev, "Failed to add PWM chip: %pe\n", ERR_PTR(ret));
+ return ret;
+ }
+
+ platform_set_drvdata(pdev, priv);
+
+ return 0;
+}
+
+static int keembay_pwm_remove(struct platform_device *pdev)
+{
+ struct keembay_pwm *priv = platform_get_drvdata(pdev);
+
+ return pwmchip_remove(&priv->chip);
+}
+
+static const struct of_device_id keembay_pwm_of_match[] = {
+ { .compatible = "intel,keembay-pwm" },
+ { }
+};
+MODULE_DEVICE_TABLE(of, keembay_pwm_of_match);
+
+static struct platform_driver keembay_pwm_driver = {
+ .probe = keembay_pwm_probe,
+ .remove = keembay_pwm_remove,
+ .driver = {
+ .name = "pwm-keembay",
+ .of_match_table = keembay_pwm_of_match,
+ },
+};
+module_platform_driver(keembay_pwm_driver);
+
+MODULE_ALIAS("platform:pwm-keembay");
+MODULE_DESCRIPTION("Intel Keem Bay PWM driver");
+MODULE_LICENSE("GPL v2");