| Message ID | 1461320295-20414-10-git-send-email-lee.jones@linaro.org |
|---|---|
| State | Superseded |
| Headers | show |
Hi Lee, On Fri, 22 Apr 2016, Lee Jones wrote: > Here we're requesting the PWM Capture IRQ and supplying the > handler which will be called in the event of an IRQ fire to > handle it. > > Signed-off-by: Lee Jones <lee.jones@linaro.org> > --- > drivers/pwm/pwm-sti.c | 92 ++++++++++++++++++++++++++++++++++++++++++++++++++- > 1 file changed, 91 insertions(+), 1 deletion(-) > > diff --git a/drivers/pwm/pwm-sti.c b/drivers/pwm/pwm-sti.c > index 9d597bb..2230afb 100644 > --- a/drivers/pwm/pwm-sti.c > +++ b/drivers/pwm/pwm-sti.c > @@ -91,7 +91,9 @@ struct sti_pwm_chip { > struct regmap_field *prescale_low; > struct regmap_field *prescale_high; > struct regmap_field *pwm_out_en; > + struct regmap_field *pwm_cpt_en; > struct regmap_field *pwm_cpt_int_en; > + struct regmap_field *pwm_cpt_int_stat; > struct pwm_chip chip; > struct pwm_device *cur; > unsigned long configured; > @@ -311,6 +313,76 @@ static const struct pwm_ops sti_pwm_ops = { > .owner = THIS_MODULE, > }; > > +static irqreturn_t sti_pwm_interrupt(int irq, void *data) > +{ > + struct sti_pwm_chip *pc = data; > + struct device *dev = pc->dev; > + struct sti_cpt_ddata *ddata; > + int devicenum; > + unsigned int cpt_int_stat; > + unsigned int reg; > + int ret = IRQ_NONE; > + > + ret = regmap_field_read(pc->pwm_cpt_int_stat, &cpt_int_stat); > + if (ret) > + return ret; > + > + while (cpt_int_stat) { > + devicenum = ffs(cpt_int_stat) - 1; > + > + ddata = pwm_get_chip_data(&pc->chip.pwms[devicenum]); > + > + /* > + * Capture input: > + * _______ _______ > + * | | | | > + * __| |_________________| |________ > + * ^0 ^1 ^2 > + * > + * Capture start by the first available rising edge > + * When a capture event occurs, capture value (CPT_VALx) > + * is stored, index incremented, capture edge changed. > + * > + * After the capture, if the index > 1, we have collected > + * the necessary data so we signal the thread waiting for it > + * and disable the capture by setting capture edge to none > + * > + */ > + > + regmap_read(pc->regmap, > + PWM_CPT_VAL(devicenum), > + &ddata->snapshot[ddata->index]); > + > + switch (ddata->index) { > + case 0: > + case 1: > + regmap_read(pc->regmap, PWM_CPT_EDGE(devicenum), ®); > + reg ^= PWM_CPT_EDGE_MASK; > + regmap_write(pc->regmap, PWM_CPT_EDGE(devicenum), reg); > + > + ddata->index++; > + break; > + case 2: > + regmap_write(pc->regmap, > + PWM_CPT_EDGE(devicenum), > + CPT_EDGE_DISABLED); > + wake_up(&ddata->wait); > + break; > + default: > + dev_err(dev, "Internal error\n"); > + } > + > + cpt_int_stat &= ~BIT_MASK(devicenum); > + > + ret = IRQ_HANDLED; > + } > + > + /* Just ACK everything */ > + regmap_write(pc->regmap, PWM_INT_ACK, PWM_INT_ACK_MASK); > + > + return ret; > +} > + > static int sti_pwm_probe_dt(struct sti_pwm_chip *pc) > { > struct device *dev = pc->dev; > @@ -351,6 +423,11 @@ static int sti_pwm_probe_dt(struct sti_pwm_chip *pc) > if (IS_ERR(pc->pwm_cpt_int_en)) > return PTR_ERR(pc->pwm_cpt_int_en); > > + pc->pwm_cpt_int_stat = devm_regmap_field_alloc(dev, pc->regmap, > + reg_fields[PWM_CPT_INT_STAT]); > + if (PTR_ERR_OR_ZERO(pc->pwm_cpt_int_stat)) > + return PTR_ERR(pc->pwm_cpt_int_stat); > + > return 0; > } > > @@ -367,7 +444,7 @@ static int sti_pwm_probe(struct platform_device *pdev) > struct sti_pwm_chip *pc; > struct resource *res; > unsigned int devnum; > - int ret; > + int irq, ret; > > pc = devm_kzalloc(dev, sizeof(*pc), GFP_KERNEL); > if (!pc) > @@ -388,6 +465,19 @@ static int sti_pwm_probe(struct platform_device *pdev) > if (IS_ERR(pc->regmap)) > return PTR_ERR(pc->regmap); > > + irq = platform_get_irq(pdev, 0); > + if (irq < 0) { > + dev_err(&pdev->dev, "Failed to obtain IRQ\n"); > + return irq; > + } > + > + ret = devm_request_irq(&pdev->dev, irq, sti_pwm_interrupt, > + 0, pdev->name, pc); > + if (ret < 0) { > + dev_err(&pdev->dev, "Failed to request IRQ\n"); > + return ret; > + } > + > /* > * Setup PWM data with default values: some values could be replaced > * with specific ones provided from Device Tree. pwm-st.txt dt binding document and pwm example needs updating to document this irq. regards, Peter -- To unsubscribe from this list: send the line "unsubscribe linux-pwm" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
On Tue, 07 Jun 2016, Peter Griffin wrote: > Hi Lee, > > On Fri, 22 Apr 2016, Lee Jones wrote: > > > Here we're requesting the PWM Capture IRQ and supplying the > > handler which will be called in the event of an IRQ fire to > > handle it. > > > > Signed-off-by: Lee Jones <lee.jones@linaro.org> > > --- > > drivers/pwm/pwm-sti.c | 92 ++++++++++++++++++++++++++++++++++++++++++++++++++- > > 1 file changed, 91 insertions(+), 1 deletion(-) > > > > diff --git a/drivers/pwm/pwm-sti.c b/drivers/pwm/pwm-sti.c > > index 9d597bb..2230afb 100644 > > --- a/drivers/pwm/pwm-sti.c > > +++ b/drivers/pwm/pwm-sti.c [...] Please cut any large chunks of unnecessary cruft when reviewing. > > @@ -367,7 +444,7 @@ static int sti_pwm_probe(struct platform_device *pdev) > > struct sti_pwm_chip *pc; > > struct resource *res; > > unsigned int devnum; > > - int ret; > > + int irq, ret; > > > > pc = devm_kzalloc(dev, sizeof(*pc), GFP_KERNEL); > > if (!pc) > > @@ -388,6 +465,19 @@ static int sti_pwm_probe(struct platform_device *pdev) > > if (IS_ERR(pc->regmap)) > > return PTR_ERR(pc->regmap); > > > > + irq = platform_get_irq(pdev, 0); > > + if (irq < 0) { > > + dev_err(&pdev->dev, "Failed to obtain IRQ\n"); > > + return irq; > > + } > > + > > + ret = devm_request_irq(&pdev->dev, irq, sti_pwm_interrupt, > > + 0, pdev->name, pc); > > + if (ret < 0) { > > + dev_err(&pdev->dev, "Failed to request IRQ\n"); > > + return ret; > > + } > > + > > /* > > * Setup PWM data with default values: some values could be replaced > > * with specific ones provided from Device Tree. > > pwm-st.txt dt binding document and pwm example needs updating to document this > irq. Yes, it does. I will update the documentation and place it into this patch-set on next submission.
diff --git a/drivers/pwm/pwm-sti.c b/drivers/pwm/pwm-sti.c index 9d597bb..2230afb 100644 --- a/drivers/pwm/pwm-sti.c +++ b/drivers/pwm/pwm-sti.c @@ -91,7 +91,9 @@ struct sti_pwm_chip { struct regmap_field *prescale_low; struct regmap_field *prescale_high; struct regmap_field *pwm_out_en; + struct regmap_field *pwm_cpt_en; struct regmap_field *pwm_cpt_int_en; + struct regmap_field *pwm_cpt_int_stat; struct pwm_chip chip; struct pwm_device *cur; unsigned long configured; @@ -311,6 +313,76 @@ static const struct pwm_ops sti_pwm_ops = { .owner = THIS_MODULE, }; +static irqreturn_t sti_pwm_interrupt(int irq, void *data) +{ + struct sti_pwm_chip *pc = data; + struct device *dev = pc->dev; + struct sti_cpt_ddata *ddata; + int devicenum; + unsigned int cpt_int_stat; + unsigned int reg; + int ret = IRQ_NONE; + + ret = regmap_field_read(pc->pwm_cpt_int_stat, &cpt_int_stat); + if (ret) + return ret; + + while (cpt_int_stat) { + devicenum = ffs(cpt_int_stat) - 1; + + ddata = pwm_get_chip_data(&pc->chip.pwms[devicenum]); + + /* + * Capture input: + * _______ _______ + * | | | | + * __| |_________________| |________ + * ^0 ^1 ^2 + * + * Capture start by the first available rising edge + * When a capture event occurs, capture value (CPT_VALx) + * is stored, index incremented, capture edge changed. + * + * After the capture, if the index > 1, we have collected + * the necessary data so we signal the thread waiting for it + * and disable the capture by setting capture edge to none + * + */ + + regmap_read(pc->regmap, + PWM_CPT_VAL(devicenum), + &ddata->snapshot[ddata->index]); + + switch (ddata->index) { + case 0: + case 1: + regmap_read(pc->regmap, PWM_CPT_EDGE(devicenum), ®); + reg ^= PWM_CPT_EDGE_MASK; + regmap_write(pc->regmap, PWM_CPT_EDGE(devicenum), reg); + + ddata->index++; + break; + case 2: + regmap_write(pc->regmap, + PWM_CPT_EDGE(devicenum), + CPT_EDGE_DISABLED); + wake_up(&ddata->wait); + break; + default: + dev_err(dev, "Internal error\n"); + } + + cpt_int_stat &= ~BIT_MASK(devicenum); + + ret = IRQ_HANDLED; + } + + /* Just ACK everything */ + regmap_write(pc->regmap, PWM_INT_ACK, PWM_INT_ACK_MASK); + + return ret; +} + static int sti_pwm_probe_dt(struct sti_pwm_chip *pc) { struct device *dev = pc->dev; @@ -351,6 +423,11 @@ static int sti_pwm_probe_dt(struct sti_pwm_chip *pc) if (IS_ERR(pc->pwm_cpt_int_en)) return PTR_ERR(pc->pwm_cpt_int_en); + pc->pwm_cpt_int_stat = devm_regmap_field_alloc(dev, pc->regmap, + reg_fields[PWM_CPT_INT_STAT]); + if (PTR_ERR_OR_ZERO(pc->pwm_cpt_int_stat)) + return PTR_ERR(pc->pwm_cpt_int_stat); + return 0; } @@ -367,7 +444,7 @@ static int sti_pwm_probe(struct platform_device *pdev) struct sti_pwm_chip *pc; struct resource *res; unsigned int devnum; - int ret; + int irq, ret; pc = devm_kzalloc(dev, sizeof(*pc), GFP_KERNEL); if (!pc) @@ -388,6 +465,19 @@ static int sti_pwm_probe(struct platform_device *pdev) if (IS_ERR(pc->regmap)) return PTR_ERR(pc->regmap); + irq = platform_get_irq(pdev, 0); + if (irq < 0) { + dev_err(&pdev->dev, "Failed to obtain IRQ\n"); + return irq; + } + + ret = devm_request_irq(&pdev->dev, irq, sti_pwm_interrupt, + 0, pdev->name, pc); + if (ret < 0) { + dev_err(&pdev->dev, "Failed to request IRQ\n"); + return ret; + } + /* * Setup PWM data with default values: some values could be replaced * with specific ones provided from Device Tree.
Here we're requesting the PWM Capture IRQ and supplying the handler which will be called in the event of an IRQ fire to handle it. Signed-off-by: Lee Jones <lee.jones@linaro.org> --- drivers/pwm/pwm-sti.c | 92 ++++++++++++++++++++++++++++++++++++++++++++++++++- 1 file changed, 91 insertions(+), 1 deletion(-)