@@ -80,17 +80,10 @@ static int spi_nor_micron_octal_dtr_enable(struct spi_nor *nor, bool enable)
return ret;
/* Read flash ID to make sure the switch was successful. */
- op = (struct spi_mem_op)
- SPI_MEM_OP(SPI_MEM_OP_CMD(SPINOR_OP_RDID, 1),
- SPI_MEM_OP_NO_ADDR,
- SPI_MEM_OP_DUMMY(enable ? 8 : 0, 1),
- SPI_MEM_OP_DATA_IN(round_up(nor->info->id_len, 2),
- buf, 1));
-
if (enable)
- spi_nor_spimem_setup_op(nor, &op, SNOR_PROTO_8_8_8_DTR);
-
- ret = spi_mem_exec_op(nor->spimem, &op);
+ ret = spi_nor_read_id(nor, 0, 8, buf, SNOR_PROTO_8_8_8_DTR);
+ else
+ ret = spi_nor_read_id(nor, 0, 0, buf, nor->reg_proto);
if (ret)
return ret;
@@ -94,17 +94,10 @@ static int spi_nor_cypress_octal_dtr_enable(struct spi_nor *nor, bool enable)
return ret;
/* Read flash ID to make sure the switch was successful. */
- op = (struct spi_mem_op)
- SPI_MEM_OP(SPI_MEM_OP_CMD(SPINOR_OP_RDID, 1),
- SPI_MEM_OP_ADDR(enable ? 4 : 0, 0, 1),
- SPI_MEM_OP_DUMMY(enable ? 3 : 0, 1),
- SPI_MEM_OP_DATA_IN(round_up(nor->info->id_len, 2),
- buf, 1));
-
if (enable)
- spi_nor_spimem_setup_op(nor, &op, SNOR_PROTO_8_8_8_DTR);
-
- ret = spi_mem_exec_op(nor->spimem, &op);
+ ret = spi_nor_read_id(nor, 4, 3, buf, SNOR_PROTO_8_8_8_DTR);
+ else
+ ret = spi_nor_read_id(nor, 0, 0, buf, nor->reg_proto);
if (ret)
return ret;
Use spi_nor_read_id() core method to avoid duplication of code. Now the ID is read on the full SPI_NOR_MAX_ID_LEN instead of round_up(nor->info->id_len, 2), but it doesn't harm to read more ID bytes, so the change comes with no secondary effects. Signed-off-by: Tudor Ambarus <tudor.ambarus@microchip.com> --- drivers/mtd/spi-nor/micron-st.c | 13 +++---------- drivers/mtd/spi-nor/spansion.c | 13 +++---------- 2 files changed, 6 insertions(+), 20 deletions(-)