@@ -242,8 +242,24 @@ static int cs_calculate_ecc(struct nand_chip *this, const u_char *dat,
static struct cs553x_nand_controller *controllers[4];
+static int cs553x_attach_chip(struct nand_chip *chip)
+{
+ if (chip->ecc.engine_type != NAND_ECC_ENGINE_TYPE_ON_HOST)
+ return 0;
+
+ chip->ecc.size = 256;
+ chip->ecc.bytes = 3;
+ chip->ecc.hwctl = cs_enable_hwecc;
+ chip->ecc.calculate = cs_calculate_ecc;
+ chip->ecc.correct = rawnand_sw_hamming_correct;
+ chip->ecc.strength = 1;
+
+ return 0;
+}
+
static const struct nand_controller_ops cs553x_nand_controller_ops = {
.exec_op = cs553x_exec_op,
+ .attach_chip = cs553x_attach_chip,
};
static int __init cs553x_init_one(int cs, int mmio, unsigned long adr)
@@ -285,14 +301,6 @@ static int __init cs553x_init_one(int cs, int mmio, unsigned long adr)
goto out_mtd;
}
- this->ecc.engine_type = NAND_ECC_ENGINE_TYPE_ON_HOST;
- this->ecc.size = 256;
- this->ecc.bytes = 3;
- this->ecc.hwctl = cs_enable_hwecc;
- this->ecc.calculate = cs_calculate_ecc;
- this->ecc.correct = rawnand_sw_hamming_correct;
- this->ecc.strength = 1;
-
/* Enable the following for a flash based bad block table */
this->bbt_options = NAND_BBT_USE_FLASH;
The probe function is only supposed to initialize the controller hardware but not the ECC engine. Indeed, we don't know anything about the NAND chip(s) at this stage. Let's move the logic initializing the ECC engine, even pretty simple, to the ->attach_chip() hook which gets called during nand_scan() routine, after the NAND chip discovery. As the previously mentioned logic is supposed to parse the DT for us, it is likely that the chip->ecc.* entries be overwritten. So let's avoid this by moving these lines to ->attach_chip(). Fixes: d7157ff49a5b ("mtd: rawnand: Use the ECC framework user input parsing bits") Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com> --- drivers/mtd/nand/raw/cs553x_nand.c | 24 ++++++++++++++++-------- 1 file changed, 16 insertions(+), 8 deletions(-)