@@ -152,22 +152,6 @@ static int m25p80_read(struct spi_nor *nor, loff_t from, size_t len,
return 0;
}
-static int m25p80_erase(struct spi_nor *nor, loff_t offset)
-{
- struct m25p *flash = nor->priv;
-
- dev_dbg(nor->dev, "%dKiB at 0x%08x\n",
- flash->spi_nor.mtd.erasesize / 1024, (u32)offset);
-
- /* Set up command buffer. */
- flash->command[0] = nor->erase_opcode;
- m25p_addr2cmd(nor, offset, flash->command);
-
- spi_write(flash->spi, flash->command, m25p_cmdsz(nor));
-
- return 0;
-}
-
/*
* board specific setup should have ensured the SPI clock used here
* matches what the READ command supports, at least until this driver
@@ -194,7 +178,6 @@ static int m25p_probe(struct spi_device *spi)
/* install the hooks */
nor->read = m25p80_read;
nor->write = m25p80_write;
- nor->erase = m25p80_erase;
nor->write_reg = m25p80_write_reg;
nor->read_reg = m25p80_read_reg;
Just use the spi-nor default instead. Signed-off-by: Brian Norris <computersforpeace@gmail.com> --- v2: no change v1: http://lists.infradead.org/pipermail/linux-mtd/2015-October/062917.html drivers/mtd/devices/m25p80.c | 17 ----------------- 1 file changed, 17 deletions(-)