diff mbox

ARM: zynq: dt: Add GPIO node

Message ID 1405018418-23396-1-git-send-email-soren.brinkmann@xilinx.com
State New
Headers show

Commit Message

Soren Brinkmann July 10, 2014, 6:53 p.m. UTC 
Add node describing Zynq's GPIO controller.

Signed-off-by: Soren Brinkmann <soren.brinkmann@xilinx.com>
---
The GPIO driver and binding documentation is staged in Linus' GPIO tree.

	Sören

 arch/arm/boot/dts/zynq-7000.dtsi | 10 ++++++++++
 1 file changed, 10 insertions(+)

Comments

Michal Simek July 18, 2014, 9:51 a.m. UTC | #1 
On 07/10/2014 08:53 PM, Soren Brinkmann wrote:
> Add node describing Zynq's GPIO controller.
> 
> Signed-off-by: Soren Brinkmann <soren.brinkmann@xilinx.com>
> ---
> The GPIO driver and binding documentation is staged in Linus' GPIO tree.
> 
> 	Sören
> 
>  arch/arm/boot/dts/zynq-7000.dtsi | 10 ++++++++++
>  1 file changed, 10 insertions(+)

Applied for zynq dt-next when gpio driver is in mainline.

Thanks,
Michal
diff mbox

Patch

diff --git a/arch/arm/boot/dts/zynq-7000.dtsi b/arch/arm/boot/dts/zynq-7000.dtsi
index 760bbc463c5b..504cca338247 100644
--- a/arch/arm/boot/dts/zynq-7000.dtsi
+++ b/arch/arm/boot/dts/zynq-7000.dtsi
@@ -65,6 +65,16 @@ 
 		interrupt-parent = <&intc>;
 		ranges;
 
+		gpio0: gpio@e000a000 {
+			compatible = "xlnx,zynq-gpio-1.0";
+			#gpio-cells = <2>;
+			clocks = <&clkc 42>;
+			gpio-controller;
+			interrupt-parent = <&intc>;
+			interrupts = <0 20 4>;
+			reg = <0xe000a000 0x1000>;
+		};
+
 		i2c0: i2c@e0004000 {
 			compatible = "cdns,i2c-r1p10";
 			status = "disabled";