@@ -115,14 +115,14 @@ config SATA_AHCI
If unsure, say N.
-config SATA_MOBILE_LPM_POLICY
- int "Default SATA Link Power Management policy for mobile chipsets"
+config SATA_LPM_POLICY
+ int "Default SATA Link Power Management policy for low power chipsets"
range 0 4
default 0
depends on SATA_AHCI
help
Select the Default SATA Link Power Management (LPM) policy to use
- for mobile / laptop variants of chipsets / "South Bridges".
+ for chipsets / "South Bridges" designated as supporting low power.
The value set has the following meanings:
0 => Keep firmware settings
@@ -1592,7 +1592,7 @@ static int ahci_init_msi(struct pci_dev *pdev, unsigned int n_ports,
static void ahci_update_initial_lpm_policy(struct ata_port *ap,
struct ahci_host_priv *hpriv)
{
- int policy = CONFIG_SATA_MOBILE_LPM_POLICY;
+ int policy = CONFIG_SATA_LPM_POLICY;
/* Ignore processing for chipsets that don't use policy */
@@ -236,7 +236,7 @@ enum {
AHCI_HFLAG_NO_WRITE_TO_RO = (1 << 24), /* don't write to read
only registers */
AHCI_HFLAG_USE_LPM_POLICY = (1 << 25), /* chipset that should use
- SATA_MOBILE_LPM_POLICY
+ SATA_LPM_POLICY
as default lpm_policy */
AHCI_HFLAG_SUSPEND_PHYS = (1 << 26), /* handle PHYs during
suspend/resume */
`CONFIG_SATA_LPM_MOBILE_POLICY` reflects a configuration to apply only to mobile chipsets. As some desktop boards may want to use this policy by default as well, rename the configuration item to `SATA_LPM_POLICY`. Signed-off-by: Mario Limonciello <mario.limonciello@amd.com> --- changes from v1->v2: * Reword documentation in Kconfig * Change configuration item to match earlier patches drivers/ata/Kconfig | 6 +++--- drivers/ata/ahci.c | 2 +- drivers/ata/ahci.h | 2 +- 3 files changed, 5 insertions(+), 5 deletions(-)