@@ -287,7 +287,7 @@ static void optiplus_set_dma_mode(struct ata_port *ap, struct ata_device *adev)
}
/**
- * optidma_make_bits - PCI setup helper
+ * optidma_make_bits43 - PCI setup helper
* @adev: ATA device
*
* Turn the ATA device setup into PCI configuration bits
@@ -309,6 +309,7 @@ static u8 optidma_make_bits43(struct ata_device *adev)
/**
* optidma_set_mode - mode setup
* @link: link to set up
+ * @r_failed: out parameter for failed device
*
* Use the standard setup to tune the chipset and then finalise the
* configuration by writing the nibble of extra bits of data into
@@ -354,7 +355,7 @@ static struct ata_port_operations optiplus_port_ops = {
/**
* optiplus_with_udma - Look for UDMA capable setup
- * @pdev; ATA controller
+ * @pdev: ATA controller
*/
static int optiplus_with_udma(struct pci_dev *pdev)
Fixes the following W=1 kernel build warning(s): drivers/ata/pata_optidma.c:298: warning: expecting prototype for optidma_make_bits(). Prototype was for optidma_make_bits43() instead drivers/ata/pata_optidma.c:319: warning: Function parameter or member 'r_failed' not described in 'optidma_set_mode' drivers/ata/pata_optidma.c:361: warning: Function parameter or member 'pdev' not described in 'optiplus_with_udma' Cc: Jens Axboe <axboe@kernel.dk> Cc: linux-ide@vger.kernel.org Signed-off-by: Lee Jones <lee.jones@linaro.org> --- drivers/ata/pata_optidma.c | 5 +++-- 1 file changed, 3 insertions(+), 2 deletions(-)