@@ -901,40 +901,23 @@ static int ahci_pci_device_resume(struct device *dev)
static int ahci_configure_dma_masks(struct pci_dev *pdev, int using_dac)
{
+ const int dma_bits = using_dac ? 64 : 32;
int rc;
/*
* If the device fixup already set the dma_mask to some non-standard
* value, don't extend it here. This happens on STA2X11, for example.
+ *
+ * XXX: manipulating the DMA mask from platform code is completely
+ * bogus, platform code should use dev->bus_dma_mask instead..
*/
if (pdev->dma_mask && pdev->dma_mask < DMA_BIT_MASK(32))
return 0;
- if (using_dac &&
- !dma_set_mask(&pdev->dev, DMA_BIT_MASK(64))) {
- rc = dma_set_coherent_mask(&pdev->dev, DMA_BIT_MASK(64));
- if (rc) {
- rc = dma_set_coherent_mask(&pdev->dev, DMA_BIT_MASK(32));
- if (rc) {
- dev_err(&pdev->dev,
- "64-bit DMA enable failed\n");
- return rc;
- }
- }
- } else {
- rc = dma_set_mask(&pdev->dev, DMA_BIT_MASK(32));
- if (rc) {
- dev_err(&pdev->dev, "32-bit DMA enable failed\n");
- return rc;
- }
- rc = dma_set_coherent_mask(&pdev->dev, DMA_BIT_MASK(32));
- if (rc) {
- dev_err(&pdev->dev,
- "32-bit consistent DMA enable failed\n");
- return rc;
- }
- }
- return 0;
+ rc = dma_set_mask_and_coherent(&pdev->dev, DMA_BIT_MASK(dma_bits));
+ if (rc)
+ dev_err(&pdev->dev, "DMA enable failed\n");
+ return rc;
}
static void ahci_pci_print_info(struct ata_host *host)
Use the dma_set_mask_and_coherent helper to set the DMA mask. Rely on the relatively recent change that setting a larger than required mask will never fail to avoid the need for the boilerplate 32-bit fallback code. Signed-off-by: Christoph Hellwig <hch@lst.de> --- drivers/ata/ahci.c | 33 ++++++++------------------------- 1 file changed, 8 insertions(+), 25 deletions(-)