@@ -396,7 +396,7 @@ static void setup_i2c_controller(struct nmk_i2c_dev *dev)
* 2 whereas it is 3 for fast and fastplus mode of
* operation. TODO - high speed support.
*/
- div = (dev->clk_freq > 100000) ? 3 : 2;
+ div = (dev->clk_freq > I2C_STANDARD_MODE_FREQ) ? 3 : 2;
/*
* generate the mask for baud rate counters. The controller
@@ -420,7 +420,7 @@ static void setup_i2c_controller(struct nmk_i2c_dev *dev)
if (dev->sm > I2C_FREQ_MODE_FAST) {
dev_err(&dev->adev->dev,
"do not support this mode defaulting to std. mode\n");
- brcr2 = i2c_clk/(100000 * 2) & 0xffff;
+ brcr2 = i2c_clk / (I2C_STANDARD_MODE_FREQ * 2) & 0xffff;
writel((brcr1 | brcr2), dev->virtbase + I2C_BRCR);
writel(I2C_FREQ_MODE_STANDARD << 4,
dev->virtbase + I2C_CR);
@@ -949,10 +949,10 @@ static void nmk_i2c_of_probe(struct device_node *np,
{
/* Default to 100 kHz if no frequency is given in the node */
if (of_property_read_u32(np, "clock-frequency", &nmk->clk_freq))
- nmk->clk_freq = 100000;
+ nmk->clk_freq = I2C_STANDARD_MODE_FREQ;
/* This driver only supports 'standard' and 'fast' modes of operation. */
- if (nmk->clk_freq <= 100000)
+ if (nmk->clk_freq <= I2C_STANDARD_MODE_FREQ)
nmk->sm = I2C_FREQ_MODE_STANDARD;
else
nmk->sm = I2C_FREQ_MODE_FAST;
Since we have generic definitions for bus frequencies, let's use them. Cc: Linus Walleij <linus.walleij@linaro.org> Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com> --- drivers/i2c/busses/i2c-nomadik.c | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-)