@@ -13,6 +13,7 @@
*/
#include <linux/clk.h>
+#include <linux/delay.h>
#include <linux/err.h>
#include <linux/kernel.h>
#include <linux/module.h>
@@ -26,6 +27,9 @@
#include <linux/io.h>
#include <linux/log2.h>
#include <linux/spinlock.h>
+#include <linux/jiffies.h>
+
+#define OCORES_FLAG_POLL BIT(0)
/**
* @process_lock: protect I2C transfer process.
@@ -35,6 +39,7 @@ struct ocores_i2c {
void __iomem *base;
u32 reg_shift;
u32 reg_io_width;
+ unsigned long flags;
wait_queue_head_t wait;
struct i2c_adapter adap;
struct i2c_msg *msg;
@@ -246,10 +251,113 @@ static void ocores_process_timeout(struct ocores_i2c *i2c)
spin_unlock_irqrestore(&i2c->process_lock, flags);
}
-static int ocores_xfer(struct i2c_adapter *adap, struct i2c_msg *msgs, int num)
+/**
+ * Wait until something change in a given register
+ * @i2c: ocores I2C device instance
+ * @reg: register to query
+ * @mask: bitmask to apply on register value
+ * @val: expected result
+ * @timeout: timeout in jiffies
+ *
+ * Timeout is necessary to avoid to stay here forever when the chip
+ * does not answer correctly.
+ *
+ * Return: 0 on success, -ETIMEDOUT on timeout
+ */
+static int ocores_wait(struct ocores_i2c *i2c,
+ int reg, u8 mask, u8 val,
+ const unsigned long timeout)
+{
+ unsigned long j;
+
+ j = jiffies + timeout;
+ while (1) {
+ u8 status = oc_getreg(i2c, reg);
+
+ if ((status & mask) == val)
+ break;
+
+ if (time_after(jiffies, j))
+ return -ETIMEDOUT;
+ }
+ return 0;
+}
+
+/**
+ * Wait until is possible to process some data
+ * @i2c: ocores I2C device instance
+ *
+ * Used when the device is in polling mode (interrupts disabled).
+ *
+ * Return: 0 on success, -ETIMEDOUT on timeout
+ */
+static int ocores_poll_wait(struct ocores_i2c *i2c)
+{
+ u8 mask;
+ int err;
+
+ if (i2c->state == STATE_DONE || i2c->state == STATE_ERROR) {
+ /* transfer is over */
+ mask = OCI2C_STAT_BUSY;
+ } else {
+ /* on going transfer */
+ mask = OCI2C_STAT_TIP;
+ udelay((8 * 1000) / i2c->bus_clock_khz);
+ }
+
+ /*
+ * once we are here we expect to get the expected result immediately
+ * so if after 1ms we timeout then something is broken.
+ */
+ err = ocores_wait(i2c, OCI2C_STATUS, mask, 0, msecs_to_jiffies(1));
+ if (err)
+ dev_warn(i2c->adap.dev.parent,
+ "%s: STATUS timeout, bit 0x%x did not clear in 1ms\n",
+ __func__, mask);
+ return err;
+}
+
+
+/**
+ * It handles an IRQ-less transfer
+ * @i2c: ocores I2C device instance
+ *
+ * Even if IRQ are disabled, the I2C OpenCore IP behavior is exactly the same
+ * (only that IRQ are not produced). This means that we can re-use entirely
+ * ocores_isr(), we just add our polling code around it.
+ *
+ * It can run in atomic context
+ */
+static void ocores_process_polling(struct ocores_i2c *i2c)
+{
+ while (1) {
+ irqreturn_t ret;
+ int err;
+
+ err = ocores_poll_wait(i2c);
+ if (err) {
+ i2c->state = STATE_ERROR;
+ break; /* timeout */
+ }
+
+ ret = ocores_isr(-1, i2c);
+ if (ret == IRQ_NONE)
+ break; /* all messages have been transfered */
+ }
+}
+
+static int ocores_xfer_core(struct ocores_i2c *i2c,
+ struct i2c_msg *msgs, int num,
+ bool polling)
{
- struct ocores_i2c *i2c = i2c_get_adapdata(adap);
int ret;
+ u8 ctrl;
+
+ ctrl = oc_getreg(i2c, OCI2C_CONTROL);
+ if (polling)
+ oc_setreg(i2c, OCI2C_CONTROL, ctrl & ~OCI2C_CTRL_IEN);
+ else
+ oc_setreg(i2c, OCI2C_CONTROL, ctrl | OCI2C_CTRL_IEN);
i2c->msg = msgs;
i2c->pos = 0;
@@ -259,16 +367,37 @@ static int ocores_xfer(struct i2c_adapter *adap, struct i2c_msg *msgs, int num)
oc_setreg(i2c, OCI2C_DATA, i2c_8bit_addr_from_msg(i2c->msg));
oc_setreg(i2c, OCI2C_CMD, OCI2C_CMD_START);
- ret = wait_event_timeout(i2c->wait, (i2c->state == STATE_ERROR) ||
- (i2c->state == STATE_DONE), HZ);
- if (ret == 0) {
- ocores_process_timeout(i2c);
- return -ETIMEDOUT;
+ if (polling) {
+ ocores_process_polling(i2c);
+ } else {
+ ret = wait_event_timeout(i2c->wait,
+ (i2c->state == STATE_ERROR) ||
+ (i2c->state == STATE_DONE), HZ);
+ if (ret == 0) {
+ ocores_process_timeout(i2c);
+ return -ETIMEDOUT;
+ }
}
return (i2c->state == STATE_DONE) ? num : -EIO;
}
+static int ocores_xfer_polling(struct i2c_adapter *adap,
+ struct i2c_msg *msgs, int num)
+{
+ return ocores_xfer_core(i2c_get_adapdata(adap), msgs, num, true);
+}
+
+static int ocores_xfer(struct i2c_adapter *adap,
+ struct i2c_msg *msgs, int num)
+{
+ struct ocores_i2c *i2c = i2c_get_adapdata(adap);
+
+ if (i2c->flags & OCORES_FLAG_POLL)
+ return ocores_xfer_polling(adap, msgs, num);
+ return ocores_xfer_core(i2c, msgs, num, false);
+}
+
static int ocores_init(struct device *dev, struct ocores_i2c *i2c)
{
int prescale;
@@ -294,7 +423,7 @@ static int ocores_init(struct device *dev, struct ocores_i2c *i2c)
/* Init the device */
oc_setreg(i2c, OCI2C_CMD, OCI2C_CMD_IACK);
- oc_setreg(i2c, OCI2C_CONTROL, ctrl | OCI2C_CTRL_IEN | OCI2C_CTRL_EN);
+ oc_setreg(i2c, OCI2C_CONTROL, ctrl | OCI2C_CTRL_EN);
return 0;
}
@@ -451,10 +580,6 @@ static int ocores_i2c_probe(struct platform_device *pdev)
int ret;
int i;
- irq = platform_get_irq(pdev, 0);
- if (irq < 0)
- return irq;
-
i2c = devm_kzalloc(&pdev->dev, sizeof(*i2c), GFP_KERNEL);
if (!i2c)
return -ENOMEM;
@@ -509,18 +634,24 @@ static int ocores_i2c_probe(struct platform_device *pdev)
}
}
+ init_waitqueue_head(&i2c->wait);
+
+ irq = platform_get_irq(pdev, 0);
+ if (irq == -ENXIO) {
+ i2c->flags |= OCORES_FLAG_POLL;
+ } else {
+ ret = devm_request_irq(&pdev->dev, irq, ocores_isr, 0,
+ pdev->name, i2c);
+ if (ret) {
+ dev_err(&pdev->dev, "Cannot claim IRQ\n");
+ goto err_clk;
+ }
+ }
+
ret = ocores_init(&pdev->dev, i2c);
if (ret)
goto err_clk;
- init_waitqueue_head(&i2c->wait);
- ret = devm_request_irq(&pdev->dev, irq, ocores_isr, 0,
- pdev->name, i2c);
- if (ret) {
- dev_err(&pdev->dev, "Cannot claim IRQ\n");
- goto err_clk;
- }
-
/* hook up driver to tree */
platform_set_drvdata(pdev, i2c);
i2c->adap = ocores_adapter;
This driver assumes that an interrupt line is always available for the I2C master. This is not always the case and this patch adds support for a polling version. Signed-off-by: Federico Vaga <federico.vaga@cern.ch> --- drivers/i2c/busses/i2c-ocores.c | 171 +++++++++++++++++++++++++++++++++++----- 1 file changed, 151 insertions(+), 20 deletions(-)