new file mode 100644
@@ -0,0 +1,188 @@
+# SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
+# Copyright 2023 Realtek Semiconductor Corporation
+%YAML 1.2
+---
+$id: http://devicetree.org/schemas/pinctrl/realtek,rtd1619b-pinctrl.yaml#
+$schema: http://devicetree.org/meta-schemas/core.yaml#
+
+title: Realtek DHC RTD1619B Pin Controller
+
+maintainers:
+ - TY Chang <tychang@realtek.com>
+
+description:
+ The Realtek DHC RTD1619B is a high-definition media processor SoC. The
+ RTD1619B pin controller is used to control pin function, pull up/down
+ resistor, drive strength, schmitt trigger and power source.
+
+properties:
+ compatible:
+ const: realtek,rtd1619b-pinctrl
+
+ reg:
+ maxItems: 1
+
+patternProperties:
+ '^.*$':
+ if:
+ type: object
+ then:
+ allOf:
+ - $ref: pincfg-node.yaml#
+ - $ref: pinmux-node.yaml#
+
+ properties:
+ pins:
+ items:
+ enum: [ gpio_0, gpio_1, gpio_2, gpio_3, gpio_4, gpio_5, gpio_6, gpio_7,
+ gpio_8, gpio_9, gpio_10, gpio_11, gpio_12, gpio_13, gpio_14,
+ gpio_15, gpio_16, gpio_17, gpio_18, gpio_19, gpio_20, gpio_21,
+ gpio_22, gpio_23, usb_cc2, gpio_25, gpio_26, gpio_27, gpio_28,
+ gpio_29, gpio_30, gpio_31, gpio_32, gpio_33, gpio_34, gpio_35,
+ hif_data, hif_en, hif_rdy, hif_clk, gpio_40, gpio_41, gpio_42,
+ gpio_43, gpio_44, gpio_45, gpio_46, gpio_47, gpio_48, gpio_49,
+ gpio_50, usb_cc1, gpio_52, gpio_53, ir_rx, ur0_rx, ur0_tx,
+ gpio_57, gpio_58, gpio_59, gpio_60, gpio_61, gpio_62, gpio_63,
+ gpio_64, gpio_65, gpio_66, gpio_67, gpio_68, gpio_69, gpio_70,
+ gpio_71, gpio_72, gpio_73, gpio_74, gpio_75, gpio_76, emmc_cmd,
+ spi_ce_n, spi_sck, spi_so, spi_si, emmc_rst_n, emmc_dd_sb,
+ emmc_clk, emmc_data_0, emmc_data_1, emmc_data_2, emmc_data_3,
+ emmc_data_4, emmc_data_5, emmc_data_6, emmc_data_7, ur2_loc,
+ gspi_loc, sdio_loc, hi_loc, hi_width, sf_en, arm_trace_dbg_en,
+ pwm_01_open_drain_en_loc0, pwm_23_open_drain_en_loc0,
+ pwm_01_open_drain_en_loc1, pwm_23_open_drain_en_loc1,
+ ejtag_acpu_loc, ejtag_vcpu_loc, ejtag_scpu_loc, dmic_loc,
+ iso_gspi_loc, ejtag_ve3_loc, ejtag_aucpu0_loc, ejtag_aucpu1_loc ]
+
+ function:
+ enum: [ gpio, nf, nf_spi, spi, pmic, spdif, spdif_coaxial, spdif_optical_loc0,
+ spdif_optical_loc1, emmc_spi, emmc, sc1, uart0, uart1, uart2_loc0, uart2_loc1,
+ gspi_loc1, iso_gspi_loc1, i2c0, i2c1, i2c3, i2c4, i2c5, pwm0, pwm1, pwm2,
+ pwm3, etn_led, etn_phy, etn_clk, sc0, vfd, gspi_loc0, iso_gspi_loc0, pcie1,
+ pcie2, sd, sdio_loc0, sdio_loc1, hi, hi_m, dc_fan, pll_test_loc0, pll_test_loc1,
+ usb_cc1, usb_cc2, ir_rx, tdm_ai_loc0, tdm_ai_loc1, dmic_loc0, dmic_loc1,
+ ai_loc0, ai_loc1, tp0, tp1, ao, uart2_disable, gspi_disable, sdio_disable,
+ hi_loc_disable, hi_loc0, hi_width_disable, hi_width_1bit, vtc_i2si_loc0,
+ vtc_tdm_loc0, vtc_dmic_loc0, vtc_i2si_loc1, vtc_tdm_loc1, vtc_dmic_loc1,
+ vtc_i2so, ve3_ejtag_loc0, aucpu0_ejtag_loc0, aucpu1_ejtag_loc0, ve3_ejtag_loc1,
+ aucpu0_ejtag_loc1, aucpu1_ejtag_loc1, ve3_ejtag_loc2, aucpu0_ejtag_loc2,
+ aucpu1_ejtag_loc2, scpu_ejtag_loc0, acpu_ejtag_loc0, vcpu_ejtag_loc0,
+ scpu_ejtag_loc1, acpu_ejtag_loc1, vcpu_ejtag_loc1, scpu_ejtag_loc2,
+ acpu_ejtag_loc2, vcpu_ejtag_loc2, ve3_ejtag_disable, aucpu0_ejtag_disable,
+ aucpu1_ejtag_disable, acpu_ejtag_disable, vcpu_ejtag_disable,
+ scpu_ejtag_disable, iso_gspi_disable, sf_disable, sf_enable,
+ arm_trace_debug_disable, arm_trace_debug_enable, pwm_normal, pwm_open_drain,
+ standby_dbg, test_loop_dis ]
+
+ drive-strength:
+ enum: [4, 8]
+
+ bias-pull-down: true
+
+ bias-pull-up: true
+
+ bias-disable: true
+
+ input-schmitt-enable: true
+
+ input-schmitt-disable: true
+
+ drive-push-pull: true
+
+ power-source:
+ description: |
+ Valid arguments are described as below:
+ 0: power supply of 1.8V
+ 1: power supply of 3.3V
+ enum: [0, 1]
+
+ realtek,drive-strength-p:
+ description: |
+ Some of pins can be driven using the P-MOS and N-MOS transistor to
+ achieve finer adjustments. The block-diagram representation is as
+ follows:
+ VDD
+ |
+ ||--+
+ +-----o|| P-MOS-FET
+ | ||--+
+ IN --+ +----- out
+ | ||--+
+ +------|| N-MOS-FET
+ ||--+
+ |
+ GND
+ The driving strength of the P-MOS/N-MOS transistors impacts the
+ waveform's rise/fall times. Greater driving strength results in
+ shorter rise/fall times. Each P-MOS and N-MOS transistor offers
+ 8 configurable levels (0 to 7), with higher values indicating
+ greater driving strength, contributing to achieving the desired
+ speed.
+
+ The realtek,drive-strength-p is used to control the driving strength
+ of the P-MOS output.
+ $ref: /schemas/types.yaml#/definitions/uint32
+ minimum: 0
+ maximum: 7
+
+ realtek,drive-strength-n:
+ description: |
+ Similar to the realtek,drive-strength-p, the realtek,drive-strength-n
+ is used to control the driving strength of the N-MOS output.
+ $ref: /schemas/types.yaml#/definitions/uint32
+ minimum: 0
+ maximum: 7
+
+ realtek,duty-cycle:
+ description: |
+ An integer describing the level to adjust output duty cycle, controlling
+ the proportion of positive and negative waveforms in nanoseconds.
+ Valid arguments are described as below:
+ 0: 0ns
+ 2: + 0.25ns
+ 3: + 0.5ns
+ 4: -0.25ns
+ 5: -0.5ns
+ $ref: /schemas/types.yaml#/definitions/uint32
+ enum: [ 0, 2, 3, 4, 5 ]
+
+ required:
+ - pins
+
+ additionalProperties: false
+
+required:
+ - compatible
+ - reg
+
+additionalProperties: false
+
+examples:
+ - |
+ pinctrl@4e000 {
+ compatible = "realtek,rtd1619b-pinctrl";
+ reg = <0x4e000 0x130>;
+
+ emmc-hs200-pins {
+ pins = "emmc_clk",
+ "emmc_cmd",
+ "emmc_data_0",
+ "emmc_data_1",
+ "emmc_data_2",
+ "emmc_data_3",
+ "emmc_data_4",
+ "emmc_data_5",
+ "emmc_data_6",
+ "emmc_data_7";
+ function = "emmc";
+ realtek,drive-strength-p = <0x2>;
+ realtek,drive-strength-n = <0x2>;
+ };
+
+ i2c-0-pins {
+ pins = "gpio_12",
+ "gpio_13";
+ function = "i2c0";
+ drive-strength = <4>;
+ };
+ };
Add device tree bindings for RTD1619B. Signed-off-by: Tzuyi Chang <tychang@realtek.com> --- v1 to v2 change: 1. Add a description for RTD1619B. 2. Rename realtek,pdrive, realtekmndrive and realtek,dcycle. 3. Add a description for PMOS and NMOS driving strength. 4. Remove the wildcard in the compatible strings. 5. Use '-pins$' to be node name pattern. --- .../pinctrl/realtek,rtd1619b-pinctrl.yaml | 188 ++++++++++++++++++ 1 file changed, 188 insertions(+) create mode 100644 Documentation/devicetree/bindings/pinctrl/realtek,rtd1619b-pinctrl.yaml