diff mbox

[v2,04/10] gpio: stmpe: write int status register only when needed

Message ID 1461845589-4826-5-git-send-email-patrice.chotard@st.com
State New
Headers show

Commit Message

Patrice CHOTARD April 28, 2016, 12:13 p.m. UTC 
From: Patrice Chotard <patrice.chotard@st.com>

On STMPE801/1801 datasheets, it's mentionned writing
in interrupt status register has no effect, bits are
cleared when reading.

Signed-off-by: Amelie DELAUNAY <amelie.delaunay@st.com>
Signed-off-by: Patrice Chotard <patrice.chotard@st.com>
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
---
 drivers/gpio/gpio-stmpe.c | 12 ++++++++----
 1 file changed, 8 insertions(+), 4 deletions(-)
diff mbox

Patch

diff --git a/drivers/gpio/gpio-stmpe.c b/drivers/gpio/gpio-stmpe.c
index bfc918c..2789bdc 100644
--- a/drivers/gpio/gpio-stmpe.c
+++ b/drivers/gpio/gpio-stmpe.c
@@ -355,12 +355,16 @@  static irqreturn_t stmpe_gpio_irq(int irq, void *dev)
 			stat &= ~(1 << bit);
 		}
 
-		stmpe_reg_write(stmpe, statmsbreg + i, status[i]);
-
-		/* Edge detect register is not present on 801 and 1801 */
-		if (stmpe->partnum != STMPE801 || stmpe->partnum != STMPE1801)
+		/*
+		 * interrupt status register write has no effect on
+		 * 801 and 1801, bits are cleared when read.
+		 * Edge detect register is not present on 801 and 1801
+		 */
+		if (stmpe->partnum != STMPE801 || stmpe->partnum != STMPE1801) {
+			stmpe_reg_write(stmpe, statmsbreg + i, status[i]);
 			stmpe_reg_write(stmpe, stmpe->regs[STMPE_IDX_GPEDR_MSB]
 					+ i, status[i]);
+		}
 	}
 
 	return IRQ_HANDLED;