Message ID | 20201113145151.68900-1-lars.povlsen@microchip.com |
---|---|
Headers | show |
Series | Adding support for Microchip/Microsemi serial GPIO controller | expand |
On Fri, Nov 13, 2020 at 3:52 PM Lars Povlsen <lars.povlsen@microchip.com> wrote: > The series add support for the serial GPIO controller used by > Microchip Sparx5, as well as (MSCC) ocelot/jaguar2 SoCs. > > v10 changes - anniversary edition (from Andy): > - Fixed "Author" comment > - Added missing "break;" in default switch case > - Return -EINVAL when requesting pin disabled in bitstream > - Change bank consistency check to return -ERANGE if failed (-EINVAL > previously) Patches 1 & 2 applied to the GPIO tree! Patch 3 needs to go to the SoC tree. Thanks for your hard work! Yours, Linus Walleij
Linus Walleij writes: > On Fri, Nov 13, 2020 at 3:52 PM Lars Povlsen <lars.povlsen@microchip.com> wrote: > >> The series add support for the serial GPIO controller used by >> Microchip Sparx5, as well as (MSCC) ocelot/jaguar2 SoCs. >> >> v10 changes - anniversary edition (from Andy): >> - Fixed "Author" comment >> - Added missing "break;" in default switch case >> - Return -EINVAL when requesting pin disabled in bitstream >> - Change bank consistency check to return -ERANGE if failed (-EINVAL >> previously) > > Patches 1 & 2 applied to the GPIO tree! Excellent! > > Patch 3 needs to go to the SoC tree. > I'll forward this in a PR for Arnd. > Thanks for your hard work! Thank you to both you and Any for good comments. ---Lars > > Yours, > Linus Walleij