diff mbox

EAP: Failed to switch EAP-SIM to EAP-AKA/AKA'

Message ID CAFk-A4=8c8_t2WutPM-0YnN+PfKCm3d5N2sM0=YCQEF3Pe=nJA@mail.gmail.com
State Superseded
Headers show

Commit Message

Masashi Honma July 30, 2013, 2:29 a.m. UTC 
Switching eap method from EAP-SIM to EAP-AKA fails.
wpa_cli commands are below.

------------------
sudo wpa_cli add_network
sudo wpa_cli set_network 0 ssid '"eap-sim"'
sudo wpa_cli set_network 0 key_mgmt WPA-EAP
sudo wpa_cli set_network 0 eap SIM
sudo wpa_cli set_network 0 pin '"1234"'
sudo wpa_cli set_network 0 pcsc '""'
sudo wpa_cli select_network 0

sudo wpa_cli disable_network 0
sudo wpa_cli disconnect
sudo wpa_cli remove_network 0

sudo wpa_cli add_network
sudo wpa_cli set_network 0 ssid '"eap-sim"'
sudo wpa_cli set_network 0 key_mgmt WPA-EAP
sudo wpa_cli set_network 0 eap AKA
sudo wpa_cli set_network 0 pin '"1234"'
sudo wpa_cli set_network 0 pcsc '""'
sudo wpa_cli select_network 0
------------------

Then EAP-AKA connection resulted in fail.
wpa_supplicant log is below.

------------------
wlan0: CTRL-EVENT-EAP-METHOD EAP vendor 0 method 23 (AKA) selected
SCARD: Non-USIM card - cannot do UMTS auth
EAP-AKA: UMTS authentication failed (AUTN)
wlan0: CTRL-EVENT-EAP-FAILURE EAP authentication failed
------------------

This occurs because on the first EAP-SIM authentication, the SIM/USIM card in
the device was recognized as SIM card even if it is USIM card.

So this patch changes it to recognize as USIM card even if EAP-SIM
authentication was required.

I have tested these switching cases.
EAP-SIM -> EAP-AKA
EAP-SIM -> EAP-AKA'
EAP-AKA -> EAP-SIM
EAP-AKA -> EAP-AKA'
EAP-AKA' -> EAP-SIM
EAP-AKA' -> EAP-AKA




Regards,
Masashi Honma.
diff mbox

Patch

diff --git a/wpa_supplicant/events.c b/wpa_supplicant/events.c
index bcfac21..2474db5 100644
--- a/wpa_supplicant/events.c
+++ b/wpa_supplicant/events.c
@@ -272,7 +272,7 @@  int wpa_supplicant_scard_init(struct wpa_supplicant *wpa_s,
 {
 #ifdef IEEE8021X_EAPOL
 #ifdef PCSC_FUNCS
-    int aka = 0, sim = 0, type;
+    int aka = 0, sim = 0;

     if (ssid->eap.pcsc == NULL || wpa_s->scard != NULL)
         return 0;
@@ -311,14 +311,9 @@  int wpa_supplicant_scard_init(struct wpa_supplicant *wpa_s,

     wpa_dbg(wpa_s, MSG_DEBUG, "Selected network is configured to use SIM "
         "(sim=%d aka=%d) - initialize PCSC", sim, aka);
-    if (sim && aka)
-        type = SCARD_TRY_BOTH;
-    else if (aka)
-        type = SCARD_USIM_ONLY;
-    else
-        type = SCARD_GSM_SIM_ONLY;

-    wpa_s->scard = scard_init(type, NULL);
+    wpa_s->scard = scard_init((!sim && aka) ?
+                  SCARD_USIM_ONLY : SCARD_TRY_BOTH, NULL);
     if (wpa_s->scard == NULL) {
         wpa_msg(wpa_s, MSG_WARNING, "Failed to initialize SIM "
             "(pcsc-lite)");