@@ -37,6 +37,42 @@ def test_ap_change_ssid(dev, apdev):
dev[0].set_network_quoted(id, "ssid", "test-wpa2-psk-new")
dev[0].connect_network(id)
+def test_ap_change_ssid_wps(dev, apdev):
+ """Dynamic SSID change with hostapd and WPA2-PSK using WPS"""
+ params = hostapd.wpa2_params(ssid="test-wpa2-psk-start",
+ passphrase="12345678")
+ # Use a psk and not the passphrase, because the psk will have to be computed again
+ # if we use a passphrase:
+ del params["wpa_passphrase"]
+ params["wpa_psk"] = "0123456789abcdef0123456789abcdef0123456789abcdef0123456789abcdef"
+
+ params.update({"wps_state": "2", "eap_server": "1"})
+ bssid = apdev[0]['bssid']
+ hapd = hostapd.add_ap(apdev[0], params)
+
+ new_ssid = "test-wpa2-psk-new"
+ logger.info("Change SSID dynamically (WPS)")
+ res = hapd.request("SET ssid " + new_ssid)
+ if "OK" not in res:
+ raise Exception("SET command failed")
+ res = hapd.request("RELOAD")
+ if "OK" not in res:
+ raise Exception("RELOAD command failed")
+
+ # Connect to the new ssid using wps:
+ hapd.request("WPS_PBC")
+ if "PBC Status: Active" not in hapd.request("WPS_GET_STATUS"):
+ raise Exception("PBC status not shown correctly")
+
+ dev[0].request("WPS_PBC")
+ dev[0].wait_connected(timeout=20)
+ status = dev[0].get_status()
+ if status['wpa_state'] != 'COMPLETED' or status['bssid'] != bssid:
+ raise Exception("Not fully connected")
+ if status['ssid'] != new_ssid:
+ raise Exception("Unexpected SSID %s != %s" % (status['ssid'], new_ssid))
+ dev[0].request("DISCONNECT")
+
def multi_check(apdev, dev, check, scan_opt=True):
id = []
num_bss = len(check)
This test first configure hsotapd with an initial SSID ('test-wpa2-psk-start'). Then a new SSID is configured ('test-wpa2-psk-new') using SET and RELOAD. Next, a station is associated using WPS, and the test verifies that the new SSID was served to the station. Signed-off-by: Raphaël Mélotte <raphael.melotte@mind.be> --- tests/hwsim/test_ap_dynamic.py | 36 ++++++++++++++++++++++++++++++++++ 1 file changed, 36 insertions(+)