new file mode 100644
@@ -0,0 +1,33 @@
+* STMicroelectronics SAS. ST21NFCA NFC Controller
+
+Required properties:
+- compatible: Should be "st,st21nfca-i2c".
+- clock-frequency: I²C work frequency.
+- reg: address on the bus
+- interrupt-parent: phandle for the interrupt gpio controller
+- interrupts: GPIO interrupt to which the chip is connected
+- enable-gpios: Output GPIO pin used for enabling/disabling the ST21NFCA
+
+Optional SoC Specific Properties:
+- pinctrl-names: Contains only one value - "default".
+- pintctrl-0: Specifies the pin control groups used for this controller.
+
+Example (for ARM-based BeagleBoard xM with ST21NFCA on I2C2):
+
+&i2c2 {
+
+ status = "okay";
+
+ st21nfca: st21nfca@1 {
+
+ compatible = "st,st21nfca_i2c";
+
+ reg = <0x01>;
+ clock-frequency = <400000>;
+
+ interrupt-parent = <&gpio5>;
+ interrupts = <2 IRQ_TYPE_LEVEL_LOW>;
+
+ enable-gpios = <&gpio5 29 GPIO_ACTIVE_HIGH>;
+ };
+};
Describe the properties used by the st21nfca NFC controller driver. Signed-off-by: Christophe Ricard <christophe-h.ricard@st.com> --- .../devicetree/bindings/net/nfc/st21nfca.txt | 33 ++++++++++++++++++++++ 1 file changed, 33 insertions(+) create mode 100644 Documentation/devicetree/bindings/net/nfc/st21nfca.txt