| Message ID | 1394829262-28022-1-git-send-email-u.kleine-koenig@pengutronix.de |
|---|---|
| State | Accepted, archived |
| Commit | f2bb31057a42cb439161066db615ca73e4438e30 |
| Headers | show |
On Fri, Mar 14, 2014 at 09:34:22PM +0100, Uwe Kleine-König wrote: > While reviewing an i2c driver for efm32 that needs a similar property > Wolfram Sang pointed out that "location" is a too generic name for > something that is efm32 specific. So add an appropriate namespace and > fall back to the generic name in case of failure. Applied, thanks.
On Fri, Mar 14, 2014 at 09:34:22PM +0100, Uwe Kleine-König wrote: > While reviewing an i2c driver for efm32 that needs a similar property > Wolfram Sang pointed out that "location" is a too generic name for > something that is efm32 specific. So add an appropriate namespace and > fall back to the generic name in case of failure. > > Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de> Acked-by: Wolfram Sang <wsa@the-dreams.de>
diff --git a/Documentation/devicetree/bindings/spi/efm32-spi.txt b/Documentation/devicetree/bindings/spi/efm32-spi.txt index a590ca51be75..25c02ba530da 100644 --- a/Documentation/devicetree/bindings/spi/efm32-spi.txt +++ b/Documentation/devicetree/bindings/spi/efm32-spi.txt @@ -8,7 +8,7 @@ Required properties: - interrupts: pair specifying rx and tx irq - clocks: phandle to the spi clock - cs-gpios: see spi-bus.txt -- location: Value to write to the ROUTE register's LOCATION bitfield to configure the pinmux for the device, see datasheet for values. +- efm32,location: Value to write to the ROUTE register's LOCATION bitfield to configure the pinmux for the device, see datasheet for values. Example: @@ -20,7 +20,7 @@ spi1: spi@0x4000c400 { /* USART1 */ interrupts = <15 16>; clocks = <&cmu 20>; cs-gpios = <&gpio 51 1>; // D3 - location = <1>; + efm32,location = <1>; status = "ok"; ks8851@0 { diff --git a/drivers/spi/spi-efm32.c b/drivers/spi/spi-efm32.c index 0512fedf1f13..fdb6fce0530b 100644 --- a/drivers/spi/spi-efm32.c +++ b/drivers/spi/spi-efm32.c @@ -294,7 +294,10 @@ static void efm32_spi_probe_dt(struct platform_device *pdev, u32 location; int ret; - ret = of_property_read_u32(np, "location", &location); + ret = of_property_read_u32(np, "efm32,location", &location); + if (ret) + /* fall back to old and (wrongly) generic property "location" */ + ret = of_property_read_u32(np, "location", &location); if (!ret) { dev_dbg(&pdev->dev, "using location %u\n", location); } else {
While reviewing an i2c driver for efm32 that needs a similar property Wolfram Sang pointed out that "location" is a too generic name for something that is efm32 specific. So add an appropriate namespace and fall back to the generic name in case of failure. Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de> --- Changes since (implicit) v1, sent with Message-Id: 1394812888-22697-1-git-send-email-u.kleine-koenig@pengutronix.de: - rebase on top of Mark's topic/efm32 branch - adapt dt binding doc accordingly Documentation/devicetree/bindings/spi/efm32-spi.txt | 4 ++-- drivers/spi/spi-efm32.c | 5 ++++- 2 files changed, 6 insertions(+), 3 deletions(-)