mbox series

[v3,0/4] arm64: dts: rockchip: add basic dts file for PX30 SoCs

Message ID 1533113116-8820-1-git-send-email-cl@rock-chips.com
Headers show
Series arm64: dts: rockchip: add basic dts file for PX30 SoCs | expand


cl@rock-chips.com Aug. 1, 2018, 8:45 a.m. UTC
From: Liang Chen <cl@rock-chips.com>

Changes in v3:
1. backlight: remove properties <brightness-levels>,<num-interpolated-steps>,
<default-brightness-level>, as the driver will compute a default table.

Changes in V2:
1. change the subject to format "dt-bindings: module: ..." for the documents. 
2. use new property <num-interpolated-steps> for backlight.
3. remove pinctrl of rk809, because the driver is not ready.

Liang Chen (4):
  dt-bindings: usb: dwc2: add description for px30
  dt-bindings: rockchip: grf: add grf and pmugrf description for px30
  arm64: dts: rockchip: add core dtsi file for PX30 SoCs
  arm64: dts: rockchip: add PX30 eavluation board devicetree

 Documentation/devicetree/bindings/arm/rockchip.txt |    4 +
 .../devicetree/bindings/soc/rockchip/grf.txt       |    2 +
 Documentation/devicetree/bindings/usb/dwc2.txt     |    1 +
 arch/arm64/boot/dts/rockchip/Makefile              |    1 +
 arch/arm64/boot/dts/rockchip/px30-evb.dts          |  470 +++++
 arch/arm64/boot/dts/rockchip/px30.dtsi             | 2043 ++++++++++++++++++++
 6 files changed, 2521 insertions(+)
 create mode 100644 arch/arm64/boot/dts/rockchip/px30-evb.dts
 create mode 100644 arch/arm64/boot/dts/rockchip/px30.dtsi


Heiko Stübner Aug. 2, 2018, 11:58 a.m. UTC | #1

Am Mittwoch, 1. August 2018, 10:45:15 CEST schrieb cl@rock-chips.com:
> From: Liang Chen <cl@rock-chips.com>
> This patch adds core dtsi file for Rockchip PX30 SoCs.
> Signed-off-by: Liang Chen <cl@rock-chips.com>

applied with the following changes:
- some reordering
- cpu properties should be present in all cpu nodes (clocks etc)
- added dma-names to uarts
- dropped #dma-cells from uarts+spi (only for dma-controllers)
- dropped phy-names from usb nodes without actual phys
  (please readd once you have phy support)
- dropped the gamma_lut + reg-names and spanned the
  registers till below the iommu, similar to all other socs we have
- dropped the high_speed pinctrl state from the spi nodes
  (not part of mainline dt-binding)
- dropped peripherals-req-type-burst from the dmac
  (not part of mainline dt-binding)
- split out dwc2 into separate patch to be applied once the binding lands
- set #sound-dai-cells in px30.dtsi ... property of the i2s controller
  and doesn't change per board


To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html