@@ -182,18 +182,14 @@
#define CONFIG_SYS_MONITOR_LEN (256 * 1024) /* Reserve 256KiB */
#define CONFIG_ENV_IS_IN_FLASH 1
-#define CONFIG_ENV_SECT_SIZE (32 * 1024)
+#define CONFIG_ENV_SECT_SIZE (128 * 1024)
#define CONFIG_ENV_SIZE CONFIG_ENV_SECT_SIZE
+#define CONFIG_ENV_ADDR (CONFIG_SYS_MONITOR_BASE + CONFIG_SYS_MONITOR_LEN)
/* Address and size of Redundant Environment Sector */
-#define CONFIG_ENV_OFFSET_REDUND (CONFIG_ENV_OFFSET + CONFIG_ENV_SIZE)
+#define CONFIG_ENV_ADDR_REDUND (CONFIG_ENV_ADDR + CONFIG_ENV_SIZE)
#define CONFIG_ENV_SIZE_REDUND CONFIG_ENV_SIZE
-/* S29WS256N NOR flash has 4 32KiB small sectors at the beginning and at the end.
- * The rest of 32MiB is in 128KiB big sectors. U-Boot occupies the low 4 sectors,
- * if we put environment next to it, we will have to occupy 128KiB for it.
- * Putting it at the top of flash we use only 32KiB. */
-#define CONFIG_ENV_ADDR (CONFIG_SYS_MONITOR_BASE + CONFIG_ENV_SECT_SIZE)
/*-----------------------------------------------------------------------
* CFI FLASH driver setup
At the moment u-boot and u-boot environment on flash have overlapping addresses, so each u-boot update erases the environment. Fix this by placing evironment right after u-boot. Also, remove confusing comment about environment location. Signed-off-by: Felix Radensky <felix@embedded-sol.com> --- include/configs/mx31ads.h | 10 +++------- 1 files changed, 3 insertions(+), 7 deletions(-)