[v2,1/3] dt-bindings: pwm: msm-vibrator: new bindings for MSM vibrator PWM

Message ID 20180926235112.25710-2-masneyb@onstation.org
State New
Headers show
Series
  • treewide: add vibrator support for various MSM SOCs
Related show

Commit Message

Brian Masney Sept. 26, 2018, 11:51 p.m.
This patch adds the device tree bindings for the vibrator PWM found on
various Qualcomm MSM SOCs.

Signed-off-by: Brian Masney <masneyb@onstation.org>
---
 .../bindings/pwm/pwm-msm-vibrator.txt         | 38 +++++++++++++++++++
 1 file changed, 38 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/pwm/pwm-msm-vibrator.txt

Patch

diff --git a/Documentation/devicetree/bindings/pwm/pwm-msm-vibrator.txt b/Documentation/devicetree/bindings/pwm/pwm-msm-vibrator.txt
new file mode 100644
index 000000000000..44bb8b979c60
--- /dev/null
+++ b/Documentation/devicetree/bindings/pwm/pwm-msm-vibrator.txt
@@ -0,0 +1,38 @@ 
+* Device tree bindings for the vibrator PWM on various MSM SOCs.
+
+Required properties:
+
+  - compatible: Should be one of
+		"qcom,msm8226-pwm-vibrator"
+		"qcom,msm8974-pwm-vibrator"
+  - reg: the base address and length of the IO memory for the registers.
+  - #pwm-cells: set to 3.
+  - pinctrl-names: set to default.
+  - pinctrl-0: phandles pointing to pin configuration nodes. See
+               Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt
+  - clock-names: set to pwm
+  - clocks: phandle of the clock used by the PWM module. See
+            Documentation/devicetree/bindings/clock/clock-bindings.txt
+  - enable-gpios: GPIO that enables the PWM.
+
+Optional properties:
+
+  - vcc-supply: phandle to the regulator that provides power to the sensor.
+
+Example from a LG Nexus 5 (hammerhead) phone:
+
+msm_pwm_vibrator_enable: pwm@fd8c3450 {
+	reg = <0xfd8c3450 0x400>;
+	compatible = "qcom,msm8974-pwm-vibrator";
+	#pwm-cells = <3>;
+
+	vcc-supply = <&pm8941_l19>;
+
+	clocks = <&mmcc CAMSS_GP1_CLK>;
+	clock-names = "pwm";
+
+	enable-gpios = <&msmgpio 60 GPIO_ACTIVE_HIGH>;
+
+	pinctrl-names = "default";
+	pinctrl-0 = <&vibrator_pin>;
+};