Message ID | 20180617214058.6926-1-stefan@agner.ch |
---|---|
State | Accepted, archived |
Delegated to: | David Miller |
Headers | show |
Series | [v2] net: hamradio: use eth_broadcast_addr | expand |
From: Stefan Agner <stefan@agner.ch> Date: Sun, 17 Jun 2018 23:40:53 +0200 > The array bpq_eth_addr is only used to get the size of an > address, whereas the bcast_addr is used to set the broadcast > address. This leads to a warning when using clang: > drivers/net/hamradio/bpqether.c:94:13: warning: variable 'bpq_eth_addr' is not > needed and will not be emitted [-Wunneeded-internal-declaration] > static char bpq_eth_addr[6]; > ^ > > Remove both variables and use the common eth_broadcast_addr > to set the broadcast address. > > Signed-off-by: Stefan Agner <stefan@agner.ch> Applied.
diff --git a/drivers/net/hamradio/bpqether.c b/drivers/net/hamradio/bpqether.c index f347fd9c5b28..777fa59f5e0c 100644 --- a/drivers/net/hamradio/bpqether.c +++ b/drivers/net/hamradio/bpqether.c @@ -89,10 +89,6 @@ static const char banner[] __initconst = KERN_INFO \ "AX.25: bpqether driver version 004\n"; -static char bcast_addr[6]={0xFF,0xFF,0xFF,0xFF,0xFF,0xFF}; - -static char bpq_eth_addr[6]; - static int bpq_rcv(struct sk_buff *, struct net_device *, struct packet_type *, struct net_device *); static int bpq_device_event(struct notifier_block *, unsigned long, void *); @@ -501,8 +497,8 @@ static int bpq_new_device(struct net_device *edev) bpq->ethdev = edev; bpq->axdev = ndev; - memcpy(bpq->dest_addr, bcast_addr, sizeof(bpq_eth_addr)); - memcpy(bpq->acpt_addr, bcast_addr, sizeof(bpq_eth_addr)); + eth_broadcast_addr(bpq->dest_addr); + eth_broadcast_addr(bpq->acpt_addr); err = register_netdevice(ndev); if (err)
The array bpq_eth_addr is only used to get the size of an address, whereas the bcast_addr is used to set the broadcast address. This leads to a warning when using clang: drivers/net/hamradio/bpqether.c:94:13: warning: variable 'bpq_eth_addr' is not needed and will not be emitted [-Wunneeded-internal-declaration] static char bpq_eth_addr[6]; ^ Remove both variables and use the common eth_broadcast_addr to set the broadcast address. Signed-off-by: Stefan Agner <stefan@agner.ch> --- drivers/net/hamradio/bpqether.c | 8 ++------ 1 file changed, 2 insertions(+), 6 deletions(-)