@@ -15395,6 +15395,8 @@ static int __devinit tg3_init_one(struct pci_dev *pdev,
pdev->dma_mask == DMA_BIT_MASK(32) ? 32 :
((u64)pdev->dma_mask) == DMA_BIT_MASK(40) ? 40 : 64);
+ pci_save_state(pdev);
+
return 0;
err_out_apeunmap:
@@ -15551,11 +15553,156 @@ static SIMPLE_DEV_PM_OPS(tg3_pm_ops, tg3_suspend, tg3_resume);
#endif /* CONFIG_PM_SLEEP */
+/**
+ * tg3_io_error_detected - called when PCI error is detected
+ * @pdev: Pointer to PCI device
+ * @state: The current pci connection state
+ *
+ * This function is called after a PCI bus error affecting
+ * this device has been detected.
+ */
+static pci_ers_result_t tg3_io_error_detected(struct pci_dev *pdev,
+ pci_channel_state_t state)
+{
+ struct net_device *netdev = pci_get_drvdata(pdev);
+ struct tg3 *tp = netdev_priv(netdev);
+ pci_ers_result_t err = PCI_ERS_RESULT_NEED_RESET;
+
+ netdev_info(netdev, "PCI I/O error detected\n");
+
+ rtnl_lock();
+
+ if (!netif_running(netdev))
+ goto done;
+
+ tg3_phy_stop(tp);
+
+ tg3_netif_stop(tp);
+
+ del_timer_sync(&tp->timer);
+ tp->tg3_flags2 &= ~TG3_FLG2_RESTART_TIMER;
+
+ /* Want to make sure that the reset task doesn't run */
+ cancel_work_sync(&tp->reset_task);
+ tp->tg3_flags &= ~TG3_FLAG_TX_RECOVERY_PENDING;
+ tp->tg3_flags2 &= ~TG3_FLG2_RESTART_TIMER;
+
+ netif_device_detach(netdev);
+
+ /* Clean up software state, even if MMIO is blocked */
+ tg3_full_lock(tp, 0);
+ tg3_halt(tp, RESET_KIND_SHUTDOWN, 0);
+ tg3_full_unlock(tp);
+
+done:
+ if (state == pci_channel_io_perm_failure)
+ err = PCI_ERS_RESULT_DISCONNECT;
+ else
+ pci_disable_device(pdev);
+
+ rtnl_unlock();
+
+ return err;
+}
+
+/**
+ * tg3_io_slot_reset - called after the pci bus has been reset.
+ * @pdev: Pointer to PCI device
+ *
+ * Restart the card from scratch, as if from a cold-boot.
+ * At this point, the card has exprienced a hard reset,
+ * followed by fixups by BIOS, and has its config space
+ * set up identically to what it was at cold boot.
+ */
+static pci_ers_result_t tg3_io_slot_reset(struct pci_dev *pdev)
+{
+ struct net_device *netdev = pci_get_drvdata(pdev);
+ struct tg3 *tp = netdev_priv(netdev);
+ pci_ers_result_t rc = PCI_ERS_RESULT_DISCONNECT;
+ int err;
+
+ rtnl_lock();
+
+ if (pci_enable_device(pdev)) {
+ netdev_err(netdev, "Cannot re-enable PCI device after reset.\n");
+ goto done;
+ }
+
+ pci_set_master(pdev);
+ pci_restore_state(pdev);
+ pci_save_state(pdev);
+
+ if (!netif_running(netdev)) {
+ rc = PCI_ERS_RESULT_RECOVERED;
+ goto done;
+ }
+
+ err = tg3_power_up(tp);
+ if (err) {
+ netdev_err(netdev, "Failed to restore register access.\n");
+ goto done;
+ }
+
+ rc = PCI_ERS_RESULT_RECOVERED;
+
+done:
+ rtnl_unlock();
+
+ return rc;
+}
+
+/**
+ * tg3_io_resume - called when traffic can start flowing again.
+ * @pdev: Pointer to PCI device
+ *
+ * This callback is called when the error recovery driver tells
+ * us that its OK to resume normal operation.
+ */
+static void tg3_io_resume(struct pci_dev *pdev)
+{
+ struct net_device *netdev = pci_get_drvdata(pdev);
+ struct tg3 *tp = netdev_priv(netdev);
+ int err;
+
+ rtnl_lock();
+
+ if (!netif_running(netdev))
+ goto done;
+
+ tg3_full_lock(tp, 0);
+ tp->tg3_flags |= TG3_FLAG_INIT_COMPLETE;
+ err = tg3_restart_hw(tp, 1);
+ tg3_full_unlock(tp);
+ if (err) {
+ netdev_err(netdev, "Cannot restart hardware after reset.\n");
+ goto done;
+ }
+
+ netif_device_attach(netdev);
+
+ tp->timer.expires = jiffies + tp->timer_offset;
+ add_timer(&tp->timer);
+
+ tg3_netif_start(tp);
+
+ tg3_phy_start(tp);
+
+done:
+ rtnl_unlock();
+}
+
+static struct pci_error_handlers tg3_err_handler = {
+ .error_detected = tg3_io_error_detected,
+ .slot_reset = tg3_io_slot_reset,
+ .resume = tg3_io_resume
+};
+
static struct pci_driver tg3_driver = {
.name = DRV_MODULE_NAME,
.id_table = tg3_pci_tbl,
.probe = tg3_init_one,
.remove = __devexit_p(tg3_remove_one),
+ .err_handler = &tg3_err_handler,
.driver.pm = TG3_PM_OPS,
};