diff mbox series

[U-Boot,v5,7/7] bootcount: display5: config: Enable boot count feature in the display5 board

Message ID 20180502141056.23937-8-lukma@denx.de
State Accepted
Delegated to: Tom Rini
Headers show
Series Provide SPL support for bootcount (in the case of using falcon boot mode) | expand

Commit Message

Lukasz Majewski May 2, 2018, 2:10 p.m. UTC 
The boot count is enabled in both SPL and proper u-boot.

Signed-off-by: Lukasz Majewski <lukma@denx.de>
Reviewed-by: Stefan Roese <sr@denx.de>

---

Changes in v5:
- None

Changes in v4:
- None

Changes in v3:
- None

Changes in v2:
- None

 configs/display5_defconfig | 4 ++++
 1 file changed, 4 insertions(+)

Comments

Tom Rini May 11, 2018, 11:08 a.m. UTC | #1 
On Wed, May 02, 2018 at 04:10:56PM +0200, Lukasz Majewski wrote:

> The boot count is enabled in both SPL and proper u-boot.
> 
> Signed-off-by: Lukasz Majewski <lukma@denx.de>
> Reviewed-by: Stefan Roese <sr@denx.de>

Applied to u-boot/master, thanks!
diff mbox series

Patch

diff --git a/configs/display5_defconfig b/configs/display5_defconfig
index e52f4e00af..db8212ca7c 100644
--- a/configs/display5_defconfig
+++ b/configs/display5_defconfig
@@ -16,6 +16,7 @@  CONFIG_SPL_LOAD_FIT=y
 CONFIG_OF_BOARD_SETUP=y
 CONFIG_SYS_EXTRA_OPTIONS="IMX_CONFIG=arch/arm/mach-imx/spl_sd.cfg,MX6Q"
 CONFIG_SUPPORT_RAW_INITRD=y
+CONFIG_SPL_BOOTCOUNT_LIMIT=y
 # CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR is not set
 CONFIG_SPL_DMA_SUPPORT=y
 CONFIG_SPL_ENV_SUPPORT=y
@@ -53,6 +54,9 @@  CONFIG_EFI_PARTITION=y
 CONFIG_OF_CONTROL=y
 CONFIG_ENV_IS_IN_SPI_FLASH=y
 CONFIG_FSL_ESDHC=y
+CONFIG_BOOTCOUNT_LIMIT=y
+CONFIG_SYS_BOOTCOUNT_SINGLEWORD=y
+CONFIG_SYS_BOOTCOUNT_ADDR=0x020CC068
 CONFIG_SPI_FLASH=y
 CONFIG_SPI_FLASH_BAR=y
 CONFIG_SPI_FLASH_SPANSION=y