@@ -2815,6 +2815,16 @@ int nand_reset(struct nand_chip *chip, int chipnr)
if (ret)
return ret;
+ /*
+ * A nand_reset_data_interface() put both the NAND chip and the NAND
+ * controller in timings mode 0. If the default mode for this chip is
+ * also 0, no need to proceed to the change again. Plus, at probe time,
+ * nand_setup_data_interface() uses ->set/get_features() which would
+ * fail anyway as the parameter page is not available yet.
+ */
+ if (!chip->onfi_timing_mode_default)
+ return 0;
+
chip->data_interface = saved_data_intf;
ret = nand_setup_data_interface(chip, chipnr);
if (ret)
After a nand_reset_data_interface(), both the NAND chip and the NAND controller use timing mode 0. The previously defined data interface for this chip has been saved and is supposed to be restored after that. However, if the saved data interface also refers to timing mode 0, there is no need to re-apply them again. Also, as nand_setup_data_interface() uses ->set/get_features(), it could lead to issues when doing the reset at probe time as the parameter page is not available yet to know if these functions are supported or not. Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com> --- drivers/mtd/nand/raw/nand_base.c | 10 ++++++++++ 1 file changed, 10 insertions(+)