[1/6] mtd: nand: Avoid setting again the timings to mode 0 after a reset

Message ID 20180203095544.9855-2-miquel.raynal@bootlin.com
State New
Delegated to: Boris Brezillon
Headers show
Series
  • Improve timings handling in the NAND framework
Related show

Commit Message

Miquel Raynal Feb. 3, 2018, 9:55 a.m.
After a nand_reset_data_interface(), both the NAND chip and the NAND
controller use timing mode 0. The previously defined data interface for
this chip has been saved and is supposed to be restored after that.
However, if the saved data interface also refers to timing mode 0, there
is no need to re-apply them again.

Also, as nand_setup_data_interface() uses ->set/get_features(), it could
lead to issues when doing the reset at probe time as the parameter page
is not available yet to know if these functions are supported or not.

Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>
---
 drivers/mtd/nand/nand_base.c | 10 ++++++++++
 1 file changed, 10 insertions(+)

Patch

diff --git a/drivers/mtd/nand/nand_base.c b/drivers/mtd/nand/nand_base.c
index 9602d17845e2..00111e669c11 100644
--- a/drivers/mtd/nand/nand_base.c
+++ b/drivers/mtd/nand/nand_base.c
@@ -2771,6 +2771,16 @@  int nand_reset(struct nand_chip *chip, int chipnr)
 	if (ret)
 		return ret;
 
+	/*
+	 * A nand_reset_data_interface() put both the NAND chip and the NAND
+	 * controller in timings mode 0. If the default mode for this chip is
+	 * also 0, no need to proceed to the change again. Plus, at probe time,
+	 * nand_setup_data_interface() uses ->set/get_features() which would
+	 * fail anyway as the parameter page is not available yet.
+	 */
+	if (!chip->onfi_timing_mode_default)
+		return 0;
+
 	chip->data_interface = saved_data_intf;
 	ret = nand_setup_data_interface(chip, chipnr);
 	if (ret)