new file mode 100644
@@ -0,0 +1,41 @@
+#include "sunxi-u-boot.dtsi"
+
+/ {
+ aliases {
+ ethernet0 = &emac;
+ };
+
+ soc {
+ emac: ethernet@01c30000 {
+ compatible = "allwinner,sun8i-a83t-emac";
+ reg = <0x01c30000 0x2000>, <0x01c00030 0x4>;
+ reg-names = "emac", "syscon";
+ interrupts = <GIC_SPI 82 IRQ_TYPE_LEVEL_HIGH>;
+ #address-cells = <1>;
+ #size-cells = <0>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&rgmii_pins>;
+ phy-mode = "rgmii";
+ phy = <&phy1>;
+ allwinner,rx-delay-ps = <700>;
+ allwinner,tx-delay-ps = <700>;
+ status = "okay";
+
+ phy1: ethernet-phy@1 {
+ reg = <1>;
+ };
+ };
+ };
+};
+
+&pio {
+ rgmii_pins: rgmii_pins {
+ allwinner,pins = "PD8", "PD9", "PD10", "PD11",
+ "PD12", "PD13", "PD15",
+ "PD16", "PD17", "PD18", "PD19",
+ "PD20", "PD21", "PD22", "PD23";
+ allwinner,function = "emac";
+ allwinner,drive = <3>;
+ allwinner,pull = <0>;
+ };
+};
@@ -23,6 +23,7 @@ CONFIG_SPL=y
# CONFIG_SPL_DOS_PARTITION is not set
# CONFIG_SPL_ISO_PARTITION is not set
# CONFIG_SPL_EFI_PARTITION is not set
+CONFIG_SUN8I_EMAC=y
CONFIG_AXP_DCDC5_VOLT=1200
CONFIG_AXP_DLDO3_VOLT=2500
CONFIG_AXP_SW_ON=y
The Bananapi M3 has an RTL8211E PHY connected to the EMAC using RGMII. The PHY is powered by DCDC1 through SW @ 3.3V. This patch adds a U-boot specific dtsi file for the board adding an enabled EMAC node, and enables the EMAC driver in the defconfig. The binding used here is the old revision currently supported in U-boot. There is no stable binding nor support in upstream Linux at this time. Signed-off-by: Chen-Yu Tsai <wens@csie.org> --- arch/arm/dts/sun8i-a83t-bananapi-m3-u-boot.dtsi | 41 +++++++++++++++++++++++++ configs/Sinovoip_BPI_M3_defconfig | 1 + 2 files changed, 42 insertions(+) create mode 100644 arch/arm/dts/sun8i-a83t-bananapi-m3-u-boot.dtsi