@@ -521,22 +521,6 @@ static u8 bnx2x_emac_enable(struct link_params *params,
/* enable emac and not bmac */
REG_WR(bp, NIG_REG_EGRESS_EMAC0_PORT + port*4, 1);
- /* for paladium */
- if (CHIP_REV_IS_EMUL(bp)) {
- /* Use lane 1 (of lanes 0-3) */
- REG_WR(bp, NIG_REG_XGXS_LANE_SEL_P0 + port*4, 1);
- REG_WR(bp, NIG_REG_XGXS_SERDES0_MODE_SEL + port*4, 1);
- }
- /* for fpga */
- else
-
- if (CHIP_REV_IS_FPGA(bp)) {
- /* Use lane 1 (of lanes 0-3) */
- DP(NETIF_MSG_LINK, "bnx2x_emac_enable: Setting FPGA\n");
-
- REG_WR(bp, NIG_REG_XGXS_LANE_SEL_P0 + port*4, 1);
- REG_WR(bp, NIG_REG_XGXS_SERDES0_MODE_SEL + port*4, 0);
- } else
/* ASIC */
if (vars->phy_flags & PHY_XGXS_FLAG) {
u32 ser_lane = ((params->lane_config &
@@ -654,15 +638,7 @@ static u8 bnx2x_emac_enable(struct link_params *params,
REG_WR(bp, NIG_REG_EMAC0_PAUSE_OUT_EN + port*4, val);
REG_WR(bp, NIG_REG_EGRESS_EMAC0_OUT_EN + port*4, 0x1);
- if (CHIP_REV_IS_EMUL(bp)) {
- /* take the BigMac out of reset */
- REG_WR(bp, GRCBASE_MISC + MISC_REGISTERS_RESET_REG_2_SET,
- (MISC_REGISTERS_RESET_REG_2_RST_BMAC0 << port));
-
- /* enable access for bmac registers */
- REG_WR(bp, NIG_REG_BMAC0_REGS_OUT_EN + port*4, 0x1);
- } else
- REG_WR(bp, NIG_REG_BMAC0_REGS_OUT_EN + port*4, 0x0);
+ REG_WR(bp, NIG_REG_BMAC0_REGS_OUT_EN + port*4, 0x0);
vars->mac_type = MAC_TYPE_EMAC;
return 0;
@@ -1086,14 +1062,6 @@ static u8 bnx2x_bmac1_enable(struct link_params *params,
wb_data[1] = 0;
REG_WR_DMAE(bp, bmac_addr + BIGMAC_REGISTER_RX_LLFC_MSG_FLDS,
wb_data, 2);
- /* fix for emulation */
- if (CHIP_REV_IS_EMUL(bp)) {
- wb_data[0] = 0xf000;
- wb_data[1] = 0;
- REG_WR_DMAE(bp, bmac_addr + BIGMAC_REGISTER_TX_PAUSE_THRESHOLD,
- wb_data, 2);
- }
-
return 0;
}
@@ -7710,57 +7678,6 @@ u8 bnx2x_phy_init(struct link_params *params, struct link_vars *vars)
set_phy_vars(params);
DP(NETIF_MSG_LINK, "Num of phys on board: %d\n", params->num_phys);
- if (CHIP_REV_IS_FPGA(bp)) {
-
- vars->link_up = 1;
- vars->line_speed = SPEED_10000;
- vars->duplex = DUPLEX_FULL;
- vars->flow_ctrl = BNX2X_FLOW_CTRL_NONE;
- vars->link_status = (LINK_STATUS_LINK_UP | LINK_10GTFD);
- /* enable on E1.5 FPGA */
- if (CHIP_IS_E1H(bp)) {
- vars->flow_ctrl |=
- (BNX2X_FLOW_CTRL_TX |
- BNX2X_FLOW_CTRL_RX);
- vars->link_status |=
- (LINK_STATUS_TX_FLOW_CONTROL_ENABLED |
- LINK_STATUS_RX_FLOW_CONTROL_ENABLED);
- }
-
- bnx2x_emac_enable(params, vars, 0);
- if (!(CHIP_IS_E2(bp)))
- bnx2x_pbf_update(params, vars->flow_ctrl,
- vars->line_speed);
- /* disable drain */
- REG_WR(bp, NIG_REG_EGRESS_DRAIN0_MODE + params->port*4, 0);
-
- /* update shared memory */
- bnx2x_update_mng(params, vars->link_status);
-
- return 0;
-
- } else
- if (CHIP_REV_IS_EMUL(bp)) {
-
- vars->link_up = 1;
- vars->line_speed = SPEED_10000;
- vars->duplex = DUPLEX_FULL;
- vars->flow_ctrl = BNX2X_FLOW_CTRL_NONE;
- vars->link_status = (LINK_STATUS_LINK_UP | LINK_10GTFD);
-
- bnx2x_bmac_enable(params, vars, 0);
-
- bnx2x_pbf_update(params, vars->flow_ctrl, vars->line_speed);
- /* Disable drain */
- REG_WR(bp, NIG_REG_EGRESS_DRAIN0_MODE
- + params->port*4, 0);
-
- /* update shared memory */
- bnx2x_update_mng(params, vars->link_status);
-
- return 0;
-
- } else
if (params->loopback_mode == LOOPBACK_BMAC) {
vars->link_up = 1;
@@ -8292,9 +8209,6 @@ u8 bnx2x_common_init_phy(struct bnx2x *bp, u32 shmem_base_path[],
u32 ext_phy_type, ext_phy_config;
DP(NETIF_MSG_LINK, "Begin common phy init\n");
- if (CHIP_REV_IS_EMUL(bp))
- return 0;
-
/* Check if common init was already done */
phy_ver = REG_RD(bp, shmem_base_path[0] +
offsetof(struct shmem_region,