@@ -21,15 +21,15 @@ $ make mx6sabresd_defconfig
$ make
-This will generate the SPL and u-boot.img binaries.
+This will generate the SPL and u-boot.itb binaries.
- Flash the SPL binary into the SD card:
$ sudo dd if=SPL of=/dev/sdX bs=1K seek=1 && sync
-- Flash the u-boot.img binary into the SD card:
+- Flash the u-boot.itb binary into the SD card:
-$ sudo dd if=u-boot.img of=/dev/sdX bs=1K seek=69 && sync
+$ sudo dd if=u-boot.itb of=/dev/sdX bs=1K seek=69 && sync
2. Booting from eMMC
@@ -39,7 +39,7 @@ $ make mx6sabresd_defconfig
$ make
-This will generate the SPL and u-boot.img binaries.
+This will generate the SPL and u-boot.itb binaries.
- Boot first from SD card as shown in the previous section
@@ -51,10 +51,10 @@ Mount the eMMC in the host PC:
=> ums 0 mmc 2
-- Flash SPL and u-boot.img binaries into the eMMC:
+- Flash SPL and u-boot.itb binaries into the eMMC:
$ sudo dd if=SPL of=/dev/sdX bs=1K seek=1 && sync
-$ sudo dd if=u-boot.img of=/dev/sdX bs=1K seek=69 && sync
+$ sudo dd if=u-boot.itb of=/dev/sdX bs=1K seek=69 && sync
Set SW6 to eMMC 8-bit boot: 11010110
@@ -65,15 +65,15 @@ Set SW6 to eMMC 8-bit boot: 11010110
$ make mx6sabresd_defconfig
$ make
-This will generate the SPL image called SPL and the u-boot.img.
+This will generate the SPL image called SPL and the u-boot.itb.
- Flash the SPL image into the SD card:
$ sudo dd if=SPL of=/dev/sdX bs=1K seek=1 oflag=sync status=none && sync
-- Flash the u-boot.img image into the SD card:
+- Flash the u-boot.itb image into the SD card:
-$ sudo dd if=u-boot.img of=/dev/sdX bs=1K seek=69 oflag=sync status=none && sync
+$ sudo dd if=u-boot.itb of=/dev/sdX bs=1K seek=69 oflag=sync status=none && sync
Create a partition for root file system and extract it there:
Update README since we use FIT now. Signed-off-by: Peng Fan <peng.fan@nxp.com> Cc: Fabio Estevam <fabio.estevam@nxp.com> Cc: Stefano Babic <sbabic@denx.de> --- board/freescale/mx6sabresd/README | 18 +++++++++--------- 1 file changed, 9 insertions(+), 9 deletions(-)