diff mbox

[1/2] net: phy: at803x: Fix RGMII RX and TX clock delays setup

Message ID 33ed5f4f-9939-dc00-b973-db39c16f2393@sigmadesigns.com
State Changes Requested, archived
Delegated to: David Miller
Headers show

Commit Message

Marc Gonzalez July 19, 2017, 3:31 p.m. UTC 
The current code supports enabling RGMII RX and TX clock delays.
The unstated assumption is that these settings are disabled by
default at reset, which is not the case.

RX clock delay is enabled at reset. And TX clock delay "survives"
across SW resets. Thus, if the bootloader enables TX clock delay,
it will remain enabled at reset in Linux.

Provide disable functions to configure the RGMII clock delays
exactly as specified in the fwspec.

Signed-off-by: Marc Gonzalez <marc_gonzalez@sigmadesigns.com>
---
 drivers/net/phy/at803x.c | 32 ++++++++++++++++++++++++--------
 1 file changed, 24 insertions(+), 8 deletions(-)

Comments

Timur Tabi July 19, 2017, 5:49 p.m. UTC | #1 
On 07/19/2017 10:31 AM, Marc Gonzalez wrote:
> The current code supports enabling RGMII RX and TX clock delays.
> The unstated assumption is that these settings are disabled by
> default at reset, which is not the case.
> 
> RX clock delay is enabled at reset. And TX clock delay "survives"
> across SW resets. Thus, if the bootloader enables TX clock delay,
> it will remain enabled at reset in Linux.
> 
> Provide disable functions to configure the RGMII clock delays
> exactly as specified in the fwspec.

I only use SGMII mode, and I tested and can confirm that this patch does 
not break SGMII, so:

Acked-by: Timur Tabi <timur@codeaurora.org>
diff mbox

Patch

diff --git a/drivers/net/phy/at803x.c b/drivers/net/phy/at803x.c
index c1e52b9dc58d..9c96eaaaa2cb 100644
--- a/drivers/net/phy/at803x.c
+++ b/drivers/net/phy/at803x.c
@@ -117,12 +117,24 @@  static inline int at803x_enable_rx_delay(struct phy_device *phydev)
 					AT803X_DEBUG_RX_CLK_DLY_EN);
 }
 
+static inline int at803x_disable_rx_delay(struct phy_device *phydev)
+{
+	return at803x_debug_reg_mask(phydev, AT803X_DEBUG_REG_0,
+					AT803X_DEBUG_RX_CLK_DLY_EN, 0);
+}
+
 static inline int at803x_enable_tx_delay(struct phy_device *phydev)
 {
 	return at803x_debug_reg_mask(phydev, AT803X_DEBUG_REG_5, 0,
 					AT803X_DEBUG_TX_CLK_DLY_EN);
 }
 
+static inline int at803x_disable_tx_delay(struct phy_device *phydev)
+{
+	return at803x_debug_reg_mask(phydev, AT803X_DEBUG_REG_5,
+					AT803X_DEBUG_TX_CLK_DLY_EN, 0);
+}
+
 /* save relevant PHY registers to private copy */
 static void at803x_context_save(struct phy_device *phydev,
 				struct at803x_context *context)
@@ -284,18 +296,22 @@  static int at803x_config_init(struct phy_device *phydev)
 		return ret;
 
 	if (phydev->interface == PHY_INTERFACE_MODE_RGMII_RXID ||
-			phydev->interface == PHY_INTERFACE_MODE_RGMII_ID) {
+			phydev->interface == PHY_INTERFACE_MODE_RGMII_ID)
 		ret = at803x_enable_rx_delay(phydev);
-		if (ret < 0)
-			return ret;
-	}
+	else
+		ret = at803x_disable_rx_delay(phydev);
+
+	if (ret < 0)
+		return ret;
 
 	if (phydev->interface == PHY_INTERFACE_MODE_RGMII_TXID ||
-			phydev->interface == PHY_INTERFACE_MODE_RGMII_ID) {
+			phydev->interface == PHY_INTERFACE_MODE_RGMII_ID)
 		ret = at803x_enable_tx_delay(phydev);
-		if (ret < 0)
-			return ret;
-	}
+	else
+		ret = at803x_disable_tx_delay(phydev);
+
+	if (ret < 0)
+		return ret;
 
 	return 0;
 }