[v2,3/6] pintrl: meson: add DT node for GPIO IRQ on Meson GX
diff mbox

Message ID ff909b0e-a161-1940-c047-e1f8207e8631@gmail.com
State New
Headers show

Commit Message

Heiner Kallweit May 12, 2017, 7:13 p.m. UTC
Add the DT node for GPIO IRQ support on AMlogic Meson GX.

Signed-off-by: Heiner Kallweit <hkallweit1@gmail.com>
---
v2:
- remove syscon
---
 .../bindings/gpio/amlogic,meson-gpio-interrupt.txt | 30 ++++++++++++++++++++++
 1 file changed, 30 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/gpio/amlogic,meson-gpio-interrupt.txt

Patch
diff mbox

diff --git a/Documentation/devicetree/bindings/gpio/amlogic,meson-gpio-interrupt.txt b/Documentation/devicetree/bindings/gpio/amlogic,meson-gpio-interrupt.txt
new file mode 100644
index 00000000..ba7d3015
--- /dev/null
+++ b/Documentation/devicetree/bindings/gpio/amlogic,meson-gpio-interrupt.txt
@@ -0,0 +1,30 @@ 
+Amlogic meson GPIO interrupt controller
+
+Meson SoCs contains an interrupt controller which is able watch the SoC pads
+and generate an interrupt on edges or level. The controller is essentially a
+256 pads to 8 GIC interrupt multiplexer, with a filter block to select edge
+or level and polarity. We don't expose all 256 mux inputs because the
+documentation shows that upper part is not mapped to any pad. The actual number
+of interrupt exposed depends on the SoC.
+
+Required properties:
+
+- compatible : should be "amlogic,meson-gpio-interrupt".
+- reg : Specifies base physical address and size of the registers.
+- interrupts : list of GIC interrupts which can be used with the
+	       GPIO IRQ multiplexer
+
+Example:
+
+gpio_irq@9880 {
+	compatible = "amlogic,meson-gpio-interrupt";
+	reg = <0x0 0x09880 0x0 0x10>;
+	interrupts = <GIC_SPI 64 IRQ_TYPE_NONE>,
+		     <GIC_SPI 65 IRQ_TYPE_NONE>,
+		     <GIC_SPI 66 IRQ_TYPE_NONE>,
+		     <GIC_SPI 67 IRQ_TYPE_NONE>,
+		     <GIC_SPI 68 IRQ_TYPE_NONE>,
+		     <GIC_SPI 69 IRQ_TYPE_NONE>,
+		     <GIC_SPI 70 IRQ_TYPE_NONE>,
+		     <GIC_SPI 71 IRQ_TYPE_NONE>;
+	};