@@ -1272,14 +1272,15 @@ void setup_pmic(void)
struct pmic *p;
struct ventana_board_info ventana_info;
int board = read_eeprom(CONFIG_I2C_GSC, &ventana_info);
+ const int i2c_pmic = 1;
u32 reg;
- i2c_set_bus_num(CONFIG_I2C_PMIC);
+ i2c_set_bus_num(i2c_pmic);
/* configure PFUZE100 PMIC */
if (!i2c_probe(CONFIG_POWER_PFUZE100_I2C_ADDR)) {
debug("probed PFUZE100@0x%x\n", CONFIG_POWER_PFUZE100_I2C_ADDR);
- power_pfuze100_init(CONFIG_I2C_PMIC);
+ power_pfuze100_init(i2c_pmic);
p = pmic_get("PFUZE100");
if (p && !pmic_probe(p)) {
pmic_reg_read(p, PFUZE100_DEVICEID, ®);
@@ -1302,7 +1303,7 @@ void setup_pmic(void)
/* configure LTC3676 PMIC */
else if (!i2c_probe(CONFIG_POWER_LTC3676_I2C_ADDR)) {
debug("probed LTC3676@0x%x\n", CONFIG_POWER_LTC3676_I2C_ADDR);
- power_ltc3676_init(CONFIG_I2C_PMIC);
+ power_ltc3676_init(i2c_pmic);
p = pmic_get("LTC3676_PMIC");
if (!p || pmic_probe(p))
return;
@@ -95,7 +95,6 @@
#define CONFIG_SYS_I2C_MXC_I2C3 /* enable I2C bus 3 */
#define CONFIG_SYS_I2C_SPEED 100000
#define CONFIG_I2C_GSC 0
-#define CONFIG_I2C_PMIC 1
#define CONFIG_I2C_EDID
/* MMC Configs */
@@ -1400,7 +1400,6 @@ CONFIG_I2C_MVTWSI_BASE3
CONFIG_I2C_MVTWSI_BASE4
CONFIG_I2C_MVTWSI_BASE5
CONFIG_I2C_MXC
-CONFIG_I2C_PMIC
CONFIG_I2C_REPEATED_START
CONFIG_I2C_RTC_ADDR
CONFIG_I2C_TIMEOUT
This is only used by one board and should not be a CONFIG option. Instead it should use the driver model pmic framework. For now, just move the setting into the only board that uses it. Signed-off-by: Simon Glass <sjg@chromium.org> --- board/gateworks/gw_ventana/common.c | 7 ++++--- include/configs/gw_ventana.h | 1 - scripts/config_whitelist.txt | 1 - 3 files changed, 4 insertions(+), 5 deletions(-)