@@ -6,14 +6,12 @@
*/
#include <common.h>
-#include <mmc.h>
#include <asm/io.h>
#include <asm/arch/sama5d3_smc.h>
#include <asm/arch/at91_common.h>
#include <asm/arch/at91_rstc.h>
#include <asm/arch/gpio.h>
#include <asm/arch/clk.h>
-#include <atmel_mci.h>
#include <net.h>
#include <netdev.h>
#include <spl.h>
@@ -65,20 +63,12 @@ static void sama5d3_xplained_usb_hw_init(void)
#ifdef CONFIG_GENERIC_ATMEL_MCI
static void sama5d3_xplained_mci0_hw_init(void)
{
- at91_mci_hw_init();
-
at91_set_pio_output(AT91_PIO_PORTE, 2, 0); /* MCI0 Power */
}
#endif
int board_early_init_f(void)
{
- at91_periph_clk_enable(ATMEL_ID_PIOA);
- at91_periph_clk_enable(ATMEL_ID_PIOB);
- at91_periph_clk_enable(ATMEL_ID_PIOC);
- at91_periph_clk_enable(ATMEL_ID_PIOD);
- at91_periph_clk_enable(ATMEL_ID_PIOE);
-
at91_seriald_hw_init();
return 0;
@@ -122,15 +112,6 @@ int board_eth_init(bd_t *bis)
return 0;
}
-#ifdef CONFIG_GENERIC_ATMEL_MCI
-int board_mmc_init(bd_t *bis)
-{
- atmel_mci_init((void *)ATMEL_BASE_MCI0);
-
- return 0;
-}
-#endif
-
/* SPL */
#ifdef CONFIG_SPL_BUILD
void spl_board_init(void)
Since the introduction of the pinctrl and clk driver and the dts file, remove unneeded hard coded related code from the board file. Signed-off-by: Wenyou Yang <wenyou.yang@atmel.com> --- Changes in v2: None board/atmel/sama5d3_xplained/sama5d3_xplained.c | 19 ------------------- 1 file changed, 19 deletions(-)