new file mode 100644
@@ -0,0 +1,45 @@
+Ingenic jz47xx GPIO controller
+
+Required properties:
+ - compatible:
+ - "ingenic,jz4740-gpio" for the JZ4740 SoC
+ - "ingenic,jz4780-gpio" for the JZ4780 SoC
+
+ - reg: Base address and length of each memory resource used by the GPIO
+ controller hardware module.
+
+ - gpio-controller: Marks the device node as a GPIO controller.
+ - #gpio-cells: Should be 2. The first cell is the GPIO number and the second
+ cell specifies GPIO flags, as defined in <dt-bindings/gpio/gpio.h>. Only the
+ GPIO_ACTIVE_HIGH and GPIO_ACTIVE_LOW flags are supported.
+ - gpio-ranges: Range of pins managed by the GPIO controller.
+
+Optional properties:
+ - base: The GPIO number to use as the base for this driver.
+ - interrupt-controller: Marks the device node as an interrupt controller.
+ - interrupts: Interrupt specifier for the controllers interrupt.
+ Required if 'interrupt-controller' is specified.
+
+Please refer to gpio.txt in this directory for details of gpio-ranges property
+and the common GPIO bindings used by client devices.
+
+The GPIO controller also acts as an interrupt controller. It uses the default
+two cells specifier as described in Documentation/devicetree/bindings/
+interrupt-controller/interrupts.txt.
+
+Example:
+
+gpa: gpio-controller@10010000 {
+ compatible = "ingenic,jz4740-gpio";
+ reg = <0x10010000 0x100>;
+
+ gpio-controller;
+ gpio-ranges = <&pinctrl 0 0 32>;
+ #gpio-cells = <2>;
+
+ interrupt-controller;
+ #interrupt-cells = <2>;
+
+ interrupt-parent = <&intc>;
+ interrupts = <28>;
+};
This commit adds documentation for the devicetree bidings of the pinctrl-gpio driver, which handles GPIOs of the Ingenic SoCs currently supported by the Linux kernel. Signed-off-by: Paul Cercueil <paul@crapouillou.net> --- .../devicetree/bindings/gpio/ingenic,gpio.txt | 45 ++++++++++++++++++++++ 1 file changed, 45 insertions(+) create mode 100644 Documentation/devicetree/bindings/gpio/ingenic,gpio.txt v2: New patch