diff mbox

[U-Boot,1/3] arm: baltos: remove TI board leftover

Message ID 1480593138-31105-1-git-send-email-yegorslists@googlemail.com
State Accepted
Commit a970727067f10a0bbe5836695dc91c7cbccc6e5b
Delegated to: Tom Rini
Headers show

Commit Message

Yegor Yefremov Dec. 1, 2016, 11:52 a.m. UTC 
From: Yegor Yefremov <yegorslists@googlemail.com>

Remove unneeded pinmux configurations and TI EEPROM struct.

Signed-off-by: Yegor Yefremov <yegorslists@googlemail.com>
---
 board/vscom/baltos/board.c |  1 -
 board/vscom/baltos/board.h | 55 ------------------------------------
 board/vscom/baltos/mux.c   | 69 ----------------------------------------------
 3 files changed, 125 deletions(-)

Comments

Tom Rini Dec. 1, 2016, 3:34 p.m. UTC | #1 
On Thu, Dec 01, 2016 at 12:52:16PM +0100, yegorslists@googlemail.com wrote:

> From: Yegor Yefremov <yegorslists@googlemail.com>
> 
> Remove unneeded pinmux configurations and TI EEPROM struct.
> 
> Signed-off-by: Yegor Yefremov <yegorslists@googlemail.com>

Reviewed-by: Tom Rini <trini@konsulko.com>
diff mbox

Patch

diff --git a/board/vscom/baltos/board.c b/board/vscom/baltos/board.c
index 27056e1..dbf79a5 100644
--- a/board/vscom/baltos/board.c
+++ b/board/vscom/baltos/board.c
@@ -415,7 +415,6 @@  int board_eth_init(bd_t *bis)
 	int rv, n = 0;
 	uint8_t mac_addr[6];
 	uint32_t mac_hi, mac_lo;
-	__maybe_unused struct am335x_baseboard_id header;
 
 	/*
 	 * Note here that we're using CPSW1 since that has a 1Gbit PHY while
diff --git a/board/vscom/baltos/board.h b/board/vscom/baltos/board.h
index bcdb648..40ddd90 100644
--- a/board/vscom/baltos/board.h
+++ b/board/vscom/baltos/board.h
@@ -11,24 +11,6 @@ 
 #ifndef _BOARD_H_
 #define _BOARD_H_
 
-/*
- * TI AM335x parts define a system EEPROM that defines certain sub-fields.
- * We use these fields to in turn see what board we are on, and what
- * that might require us to set or not set.
- */
-#define HDR_NO_OF_MAC_ADDR	3
-#define HDR_ETH_ALEN		6
-#define HDR_NAME_LEN		8
-
-struct am335x_baseboard_id {
-	unsigned int  magic;
-	char name[HDR_NAME_LEN];
-	char version[4];
-	char serial[12];
-	char config[32];
-	char mac_addr[HDR_NO_OF_MAC_ADDR][HDR_ETH_ALEN];
-};
-
 typedef struct _BSP_VS_HWPARAM    // v1.0
 {
 	uint32_t Magic;
@@ -41,37 +23,6 @@  typedef struct _BSP_VS_HWPARAM    // v1.0
 	uint8_t MAC3[6];        // WL1271 WLAN
 } __attribute__ ((packed)) BSP_VS_HWPARAM;
 
-static inline int board_is_bone(struct am335x_baseboard_id *header)
-{
-	return !strncmp(header->name, "A335BONE", HDR_NAME_LEN);
-}
-
-static inline int board_is_bone_lt(struct am335x_baseboard_id *header)
-{
-	return !strncmp(header->name, "A335BNLT", HDR_NAME_LEN);
-}
-
-static inline int board_is_evm_sk(struct am335x_baseboard_id *header)
-{
-	return !strncmp("A335X_SK", header->name, HDR_NAME_LEN);
-}
-
-static inline int board_is_idk(struct am335x_baseboard_id *header)
-{
-	return !strncmp(header->config, "SKU#02", 6);
-}
-
-static inline int board_is_gp_evm(struct am335x_baseboard_id *header)
-{
-	return !strncmp("A33515BB", header->name, HDR_NAME_LEN);
-}
-
-static inline int board_is_evm_15_or_later(struct am335x_baseboard_id *header)
-{
-	return (board_is_gp_evm(header) &&
-		strncmp("1.5", header->version, 3) <= 0);
-}
-
 /*
  * We have three pin mux functions that must exist.  We must be able to enable
  * uart0, for initial output and i2c0 to read the main EEPROM.  We then have a
@@ -79,12 +30,6 @@  static inline int board_is_evm_15_or_later(struct am335x_baseboard_id *header)
  * is required on the board.
  */
 void enable_uart0_pin_mux(void);
-void enable_uart1_pin_mux(void);
-void enable_uart2_pin_mux(void);
-void enable_uart3_pin_mux(void);
-void enable_uart4_pin_mux(void);
-void enable_uart5_pin_mux(void);
-void enable_i2c0_pin_mux(void);
 void enable_i2c1_pin_mux(void);
 void enable_board_pin_mux(void);
 #endif
diff --git a/board/vscom/baltos/mux.c b/board/vscom/baltos/mux.c
index 8783b25..94410ae 100644
--- a/board/vscom/baltos/mux.c
+++ b/board/vscom/baltos/mux.c
@@ -27,36 +27,6 @@  static struct module_pin_mux uart0_pin_mux[] = {
 	{-1},
 };
 
-static struct module_pin_mux uart1_pin_mux[] = {
-	{OFFSET(uart1_rxd), (MODE(0) | PULLUP_EN | RXACTIVE)},	/* UART1_RXD */
-	{OFFSET(uart1_txd), (MODE(0) | PULLUDEN)},		/* UART1_TXD */
-	{-1},
-};
-
-static struct module_pin_mux uart2_pin_mux[] = {
-	{OFFSET(spi0_sclk), (MODE(1) | PULLUP_EN | RXACTIVE)},	/* UART2_RXD */
-	{OFFSET(spi0_d0), (MODE(1) | PULLUDEN)},		/* UART2_TXD */
-	{-1},
-};
-
-static struct module_pin_mux uart3_pin_mux[] = {
-	{OFFSET(spi0_cs1), (MODE(1) | PULLUP_EN | RXACTIVE)},	/* UART3_RXD */
-	{OFFSET(ecap0_in_pwm0_out), (MODE(1) | PULLUDEN)},	/* UART3_TXD */
-	{-1},
-};
-
-static struct module_pin_mux uart4_pin_mux[] = {
-	{OFFSET(gpmc_wait0), (MODE(6) | PULLUP_EN | RXACTIVE)},	/* UART4_RXD */
-	{OFFSET(gpmc_wpn), (MODE(6) | PULLUDEN)},		/* UART4_TXD */
-	{-1},
-};
-
-static struct module_pin_mux uart5_pin_mux[] = {
-	{OFFSET(lcd_data9), (MODE(4) | PULLUP_EN | RXACTIVE)},	/* UART5_RXD */
-	{OFFSET(lcd_data8), (MODE(4) | PULLUDEN)},		/* UART5_TXD */
-	{-1},
-};
-
 static struct module_pin_mux mmc0_pin_mux[] = {
 	{OFFSET(mmc0_dat3), (MODE(0) | RXACTIVE | PULLUP_EN)},	/* MMC0_DAT3 */
 	{OFFSET(mmc0_dat2), (MODE(0) | RXACTIVE | PULLUP_EN)},	/* MMC0_DAT2 */
@@ -68,14 +38,6 @@  static struct module_pin_mux mmc0_pin_mux[] = {
 	{-1},
 };
 
-static struct module_pin_mux i2c0_pin_mux[] = {
-	{OFFSET(i2c0_sda), (MODE(0) | RXACTIVE |
-			PULLUDEN | SLEWCTRL)}, /* I2C_DATA */
-	{OFFSET(i2c0_scl), (MODE(0) | RXACTIVE |
-			PULLUDEN | SLEWCTRL)}, /* I2C_SCLK */
-	{-1},
-};
-
 static struct module_pin_mux i2c1_pin_mux[] = {
 	{OFFSET(spi0_d1), (MODE(2) | RXACTIVE |
 			PULLUDEN | SLEWCTRL)},	/* I2C_DATA */
@@ -144,36 +106,6 @@  void enable_uart0_pin_mux(void)
 	configure_module_pin_mux(uart0_pin_mux);
 }
 
-void enable_uart1_pin_mux(void)
-{
-	configure_module_pin_mux(uart1_pin_mux);
-}
-
-void enable_uart2_pin_mux(void)
-{
-	configure_module_pin_mux(uart2_pin_mux);
-}
-
-void enable_uart3_pin_mux(void)
-{
-	configure_module_pin_mux(uart3_pin_mux);
-}
-
-void enable_uart4_pin_mux(void)
-{
-	configure_module_pin_mux(uart4_pin_mux);
-}
-
-void enable_uart5_pin_mux(void)
-{
-	configure_module_pin_mux(uart5_pin_mux);
-}
-
-void enable_i2c0_pin_mux(void)
-{
-	configure_module_pin_mux(i2c0_pin_mux);
-}
-
 void enable_i2c1_pin_mux(void)
 {
 	configure_module_pin_mux(i2c1_pin_mux);
@@ -181,7 +113,6 @@  void enable_i2c1_pin_mux(void)
 
 void enable_board_pin_mux()
 {
-	/* Baltos */
 	configure_module_pin_mux(i2c1_pin_mux);
 	configure_module_pin_mux(gpio0_7_pin_mux);
 	configure_module_pin_mux(rgmii2_pin_mux);