| Message ID | 1469007629-31757-4-git-send-email-peter.chen@nxp.com |
|---|---|
| State | Not Applicable, archived |
| Headers | show |
On Wed, Jul 20, 2016 at 05:40:26PM +0800, Peter Chen wrote: > Add optional properties for power sequence. > > Signed-off-by: Peter Chen <peter.chen@nxp.com> > --- > Documentation/devicetree/bindings/usb/usb-device.txt | 10 +++++++++- > 1 file changed, 9 insertions(+), 1 deletion(-) This probably should be put into a binding doc for the specific hub chip, but this is fine for now. Acked-by: Rob Herring <robh@kernel.org> -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
diff --git a/Documentation/devicetree/bindings/usb/usb-device.txt b/Documentation/devicetree/bindings/usb/usb-device.txt index 1c35e7b..3661dd2 100644 --- a/Documentation/devicetree/bindings/usb/usb-device.txt +++ b/Documentation/devicetree/bindings/usb/usb-device.txt @@ -13,6 +13,10 @@ Required properties: - reg: the port number which this device is connecting to, the range is 1-31. +Optional properties: +power sequence properties, see +Documentation/devicetree/bindings/power/pwrseq/pwrseq-generic.txt for detail + Example: &usb1 { @@ -21,8 +25,12 @@ Example: #address-cells = <1>; #size-cells = <0>; - hub: genesys@1 { + genesys: hub@1 { compatible = "usb5e3,608"; reg = <1>; + + clocks = <&clks IMX6SX_CLK_CKO>; + reset-gpios = <&gpio4 5 GPIO_ACTIVE_LOW>; /* hub reset pin */ + reset-duration-us = <10>; }; }
Add optional properties for power sequence. Signed-off-by: Peter Chen <peter.chen@nxp.com> --- Documentation/devicetree/bindings/usb/usb-device.txt | 10 +++++++++- 1 file changed, 9 insertions(+), 1 deletion(-)