@@ -15,6 +15,7 @@
#include <asm/io.h>
#include <usb.h>
#include <dwc3-uboot.h>
+#include <i2c.h>
DECLARE_GLOBAL_DATA_PTR;
@@ -50,6 +51,22 @@ int board_early_init_r(void)
return 0;
}
+int zynq_board_read_rom_ethaddr(unsigned char *ethaddr)
+{
+#if defined(CONFIG_ZYNQ_GEM_EEPROM_ADDR) && \
+ defined(CONFIG_ZYNQ_GEM_I2C_MAC_OFFSET) && \
+ defined(CONFIG_ZYNQ_EEPROM_BUS)
+ i2c_set_bus_num(CONFIG_ZYNQ_EEPROM_BUS);
+
+ if (eeprom_read(CONFIG_ZYNQ_GEM_EEPROM_ADDR,
+ CONFIG_ZYNQ_GEM_I2C_MAC_OFFSET,
+ ethaddr, 6))
+ printf("I2C EEPROM MAC address read failed\n");
+#endif
+
+ return 0;
+}
+
#if !defined(CONFIG_SYS_SDRAM_BASE) && !defined(CONFIG_SYS_SDRAM_SIZE)
/*
* fdt_get_reg - Fill buffer by information from DT
@@ -48,6 +48,12 @@
#define CONFIG_IDENT_STRING " Xilinx ZynqMP ZCU102"
+#define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 1
+#define CONFIG_CMD_EEPROM
+#define CONFIG_ZYNQ_EEPROM_BUS 5
+#define CONFIG_ZYNQ_GEM_EEPROM_ADDR 0x54
+#define CONFIG_ZYNQ_GEM_I2C_MAC_OFFSET 0x20
+
#define CONFIG_KERNEL_FDT_OFST_SIZE \
"kernel_offset=0x180000\0" \
"fdt_offset=0x100000\0" \
Add support for on board eeprom with programmed MAC for using in u-boot to have uniq address for every board. Most of the time uniq MAC address is on a label on the board. If address is not programmed use these command to program it. On zcu102: ZynqMP> mm.b 0 00000000: 00 ? 00 00000001: a0 ? 0a 00000002: 35 ? 35 00000003: 02 ? 02 00000004: 00 ? ef 00000005: 00 ? 67 00000006: 00 ? q i2c dev 5 i2c write 0 54 20 6 i2c md 54 20 Signed-off-by: Michal Simek <michal.simek@xilinx.com> --- board/xilinx/zynqmp/zynqmp.c | 17 +++++++++++++++++ include/configs/xilinx_zynqmp_zcu102.h | 6 ++++++ 2 files changed, 23 insertions(+)