@@ -3063,9 +3063,6 @@ static void cas_init_mac(struct cas *cp)
{
unsigned char *e = &cp->dev->dev_addr[0];
int i;
-#ifdef CONFIG_CASSINI_MULTICAST_REG_WRITE
- u32 rxcfg;
-#endif
cas_mac_reset(cp);
/* setup core arbitration weight register */
@@ -3133,23 +3130,8 @@ static void cas_init_mac(struct cas *cp)
writel(0xc200, cp->regs + REG_MAC_ADDRN(43));
writel(0x0180, cp->regs + REG_MAC_ADDRN(44));
-#ifndef CONFIG_CASSINI_MULTICAST_REG_WRITE
cp->mac_rx_cfg = cas_setup_multicast(cp);
-#else
- /* WTZ: Do what Adrian did in cas_set_multicast. Doing
- * a writel does not seem to be necessary because Cassini
- * seems to preserve the configuration when we do the reset.
- * If the chip is in trouble, though, it is not clear if we
- * can really count on this behavior. cas_set_multicast uses
- * spin_lock_irqsave, but we are called only in cas_init_hw and
- * cas_init_hw is protected by cas_lock_all, which calls
- * spin_lock_irq (so it doesn't need to save the flags, and
- * we should be OK for the writel, as that is the only
- * difference).
- */
- cp->mac_rx_cfg = rxcfg = cas_setup_multicast(cp);
- writel(rxcfg, cp->regs + REG_MAC_RX_CFG);
-#endif
+
spin_lock(&cp->stat_lock[N_TX_RINGS]);
cas_clear_mac_err(cp);
spin_unlock(&cp->stat_lock[N_TX_RINGS]);
CASSINI_MULTICAST_REG_WRITE doesn't exist in Kconfig, therefore removing all references for it from the source code. Signed-off-by: Christoph Egger <siccegge@cs.fau.de> --- drivers/net/cassini.c | 20 +------------------- 1 files changed, 1 insertions(+), 19 deletions(-)