@@ -72,6 +72,9 @@
#define BE_MAX_MTU (BE_MAX_JUMBO_FRAME_SIZE - \
(ETH_HLEN + ETH_FCS_LEN))
+/* Accommodate for QnQ configurations where VLAN insertion is enabled in HW */
+#define BE_MAX_GSO_SIZE (65535 - 2 * VLAN_HLEN)
+
#define BE_NUM_VLANS_SUPPORTED 64
#define BE_MAX_EQD 128u
#define BE_MAX_TX_FRAG_COUNT 30
@@ -1123,6 +1123,8 @@ static struct sk_buff *be_xmit_workarounds(struct be_adapter *adapter,
struct sk_buff *skb,
struct be_wrb_params *wrb_params)
{
+ int err;
+
/* Lancer, SH and BE3 in SRIOV mode have a bug wherein
* packets that are 32b or less may cause a transmit stall
* on that port. The workaround is to pad such packets
@@ -1139,6 +1141,13 @@ static struct sk_buff *be_xmit_workarounds(struct be_adapter *adapter,
return NULL;
}
+ /* The stack can send us skbs with length greater than
+ * what the HW can handle. Trim the extra bytes.
+ */
+ WARN_ON_ONCE(skb->len > BE_MAX_GSO_SIZE);
+ err = pskb_trim(skb, BE_MAX_GSO_SIZE);
+ WARN_ON(err);
+
return skb;
}
@@ -4850,7 +4859,7 @@ static void be_netdev_init(struct net_device *netdev)
netdev->flags |= IFF_MULTICAST;
- netif_set_gso_max_size(netdev, 65535 - ETH_HLEN);
+ netif_set_gso_max_size(netdev, BE_MAX_GSO_SIZE - ETH_HLEN);
netdev->netdev_ops = &be_netdev_ops;
In QnQ configurations like Flex-10 where the VLANs are inserted by the ASIC, on rare occasions the HW is encountering a scenario where the final frame length ends to be greater than what the ASIC can support. This is because when the TXULP pulls the TX WRB to check the length of the frame to be transmitted it also adds the size of VLANs to be inserted by the HW to the length of the frame indicated in the WRB, which in some cases fails the range check. This causes a UE. Avoid this by trimming the skb length to accommodate the VLAN insertion. Signed-off-by: Ajit Khaparde <ajit.khaparde@broadcom.com> --- drivers/net/ethernet/emulex/benet/be.h | 3 +++ drivers/net/ethernet/emulex/benet/be_main.c | 11 ++++++++++- 2 files changed, 13 insertions(+), 1 deletion(-)